IBM L180p manual Connecting your monitor, Figure a

ENGLISH

Connecting your monitor

Be sure to read the Safety Information located in the Monitor Safety and Warranty Information Manual before carrying out this procedure.

1.Turn off your computer and all attached devices. Next, unplug all power cords to your computer and all attached devices.

2.Connect the signal cable.

•The analog signal cable is already connected to your monitor

(See in Figure A).

•When connecting the analog signal cable, connect the free end of the attached signal cable to the 15-pin monitor port on the computer and tighten screws.

Figure A

•If you are connecting a DVI-D digital signal cable, follow Figure B.

Connect one end of the monitor signal cable to the white connector on the rear panel of the monitor. Connect the other end to the white connector on the rear panel of the computer and tighten the screws.

Figure B 9