10
2PANELDESCRIPTION
11
2
PANELDESCRIPTION
2
MONITOR KEY
➥Mute and release the CTCSS (DTCS) or 2-tone squelch mute.
Open any squelch/deactivate any mute while pushing this key.
(LMR operation only)
➥Activates one of (or two of) the following functions on each chan-
nel independently:(PMR operation only)
• Push and hold to un-mute the channel (audio is emitted; ‘Audible’
condition).
• Push to mute the channel (sets to ‘Inaudible’only).
• Push to un-mute the channel (sets to ‘Audible’only).
• Push after the communication is finished to send a ‘reset code’.
NOTE:The un-mute condition (‘Audible’condition) may auto-
matically return to the mute condition (‘Inaudible‘ condition)
after a specified period.
LOCK KEY
Push and hold to electronically lock all programmable keys except
the following:
[Call](incl. Call A and Call B), [Moni(Audi)] and [Emergency] keys.
OUTPUT POWER SELECTION KEY
Select the transmit output power temporarily or permanently, de-
pending on the pre-setting.
•Ask your dealer for the output power level for each selection.
TALK AROUND KEY
➥Push to turn the talk around function OFF.
➥Push and hold to turn the talk around function ON.
•The talk around function equalizes the transmit frequency to the re-
ceive frequency for transceiver-to-transceiver communication.
WIDE/NARROW KEY
➥Push to select the IF bandwidth to wide.
• The wide passband width can be selected from 25.0 or 20.0 kHz
using the CS-F14
CLONINGSOFTWARE
. (PMR operation only) Ask
your dealer for details.
➥Push and hold to select the IF bandwidth to narrow.
DTMF AUTODIALKEY
Push to transmit the programmed DTMFcode.
CALLKEYS
Push to transmit a 2/5-tone code.
•Call transmission is necessary before you call another station de-
pending on your signalling system.
•[Call A]and/or [Call B] keys may be available when your system em-
ploys selective ‘Individual/Group’calls. Ask your dealer which call is
assigned to each key.
EMERGENCYKEYS
➥Push and hold to transmit an emergency call.
➥When [Emergency Single (Silent)] or [Emergency Repeat
(Silent)] is pushed, an emergency call is transmitted without a
beep emission.
• If you want to cancel the emergency call, push (or push and hold)
the key again before transmitting the call.
• The emergency call is transmitted one time only or repeatedly until
receiving a control code depending on the pre-setting.
VOICE SCRAMBLER FUNCTION KEYS
➥Push to turn the voice scrambler function OFF.
➥Push and hold to turn the voice scrambler function ON.
OPT OUT KEYS
➥Push to inactivate the connected output signal level.
➥Push and hold to activate the connected output signal level.
SIREN KEY
Push to emit a siren. This function can be used for situations other
than an emergency alert such as a security alarm for example.
IC-F14_F24-2.qxd 04.7.22 0:57 PM Page 10 (1,1)