Environmental Protection/ Conservation Issues
Your washing machine uses water, energy and detergent efficiently, thereby protecting the environment and reducing your household costs.
Using your washing machine in an efficient and environmentally friendly manner:
Do not exceed recommended load.
Cottons | 5.0kg |
Add detergent according to the degree of soiling, amount of laundry and water hardness, and observe the dertergent manufacturer’s instructions.
Before Using Your Washing Machine For The First
Time
Caution
The washing machine must have been installed and connected properly (refer page 7)
Your appliance was tested before leaving the factory. To remove any water left over from testing procedures, the first washing cycle should be carried out without laundry in the machine.
Do not load any laundry.
1.Turn on water tap.
2.Pull out the detergent dispenser up to the end stop.
3.Pour approx. 1 litre of water into chamber II of the detergent dispenser.
4.Pour ½ measuring beaker of detergent into dispenser II.
5.Close the detergent dispenser.
6.Set the temperature to 600 C cottons and start the machine.
7.After the program is over turn OFF the machine.
12
FAULT DIAGNOSIS
WHY DOES IT HAPPEN?
WATER DOES NOT ENTER MACHINE/DETERGENT NOT BEING FLUSHED INTO DRUM.
qCheck water supply qPorthole door not firmly closed qWater tap not turned on qBent inlet hose qSieve on inlet valve clogged
SUDS ESCAPING FROM DETERGENT DISPENSER TRAY. / EXCESSIVE FOAM IN THE DRUM.
qDetergent used is not a washing machine detergent qExcessive detergent used
WATER LEAKAGE FROM THE MACHINE.
qInlet/Outlet hose connection loose qFluff Filter not screwed on properly qInlet hose leaking
qDrain plug not fixed properly onto Drain hose.
MACHINE DOES NOT DRAIN.
qFluff Filter clogged
qOutlet hose end above 1 mtr. from floor level
MACHINE VIBRATES STRONGLY DURING SPINNING.
qMachine not levelled properly qClothes not loaded as instructed qWater not drained completely
MACHINE DOES NOT START.
qCheck position of programme selector knob qCheck water supply
qPorthole door not closed properly
MOTOR NOISE
qIt is normal for noises to be heard while motor is running.
However wash load, belt tension and motor mounting b o l t should be checked for specified limits.
PUMP NOISE
qIt is normal for noises to be heard from the pump during the
25
