Igloo FRW197 Important Safety Instructions, Installation Instructions, ~Warning~

IMPORTANT SAFETY INSTRUCTIONS

~WARNING~

To reduce the risk of fire, electrical shock, or injury when using your appliance, follow these basic precautions:

∙Read all instructions before using the Wine Cooler.

∙DANGER or WARNING: Risk of child entrapment.

Child entrapment and suffocation are not problems of the past. Junked or abandoned appliances are still dangerous . . . even if they will “just sit in the garage a few days”.

∙Before you throw away your old Wine Cooler: Take off the door. Leave the shelves in place so that children may not easily climb inside.

∙Never allow children to operate, play with, or crawl inside the appliance.

∙Never clean appliance parts with flammable fluids. The fumes can create a fire hazard or explosion.

∙Do not store or use gasoline or any other flammable vapors and liquids in the vicinity of this or any other appliance. The fumes can create a fire hazard or explosion.

∙Do not repair or replace any part of the Wine Cooler or attempt any servicing unless specifically recommended in the user-maintenance instructions or in published user- repair instructions. Replace the fuse with the same type.

-Save these instructions-

INSTALLATION INSTRUCTIONS

ØBefore Using Your Wine Cooler

∙Remove the exterior and interior packing.

∙Check to be sure you have all of the following parts:

∙5 Shelves (4 Large / 1 small)

∙1 Instruction Manual

∙1 warranty card

∙Clean the interior surface with lukewarm water using a soft cloth.

ØInstallation of Your Wine Cooler

∙This Wine Cooler is designed to be free standing installation only, and should not be recessed or built-in (Fully recessed).

∙Place your Wine Cooler on a surface that is strong enough to support it when it is fully loaded.

∙Allow 5 inches of space between the back and sides of the Wine Cooler, which allows the proper air circulation to cool the heat sink.

∙Locate the Wine Cooler away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Extreme cold ambient temperatures may also cause the unit not to perform properly.

∙This Wine Cooler uses compressor refrigeration technology and is not designed for storage in hot areas like garages, warehouses or outdoors since it is designed to operate at a maximum of 30 degrees below the ambient temperature.

∙Avoid locating the unit in moist areas.

∙Plug the Wine Cooler into an exclusive, properly installed-grounded wall outlet. Do not under any circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning power and/or grounding should be directed toward a certified electrician or an authorized service center.

∙After plugging the Wine Cooler into a wall outlet, allow the unit to cool down for 2-3 hours before placing any items in the compartment.

2