iHome ID28 manual Listening to iPhone/iPad/iPod, Listening to FM Radio

Listening to iPhone/iPad/iPod

1.Gently dock an already playing iPhone, iPad or iPod. The unit will automatically turn on and you will hear the audio playing from your iPhone/iPad/iPod.

Note: If the playing audio loudness is too low on the iPhone/iPad/iPod, the iD28 may not detect that the

iPhone/iPad/iPod is in play mode. Press the Button to play it.

2.Press the or Button to change iPod/iPhone track forward/reverse.

3.When the iPhone/iPod is docked and in standby mode, press the Button to play it.

4.When the iPhone or iPod is in play mode, press the Button to pause play; press again to resume play.

6.Press the Volume or Button to adjust the unit volume.

7.Press the eq Button as needed to cycle through treble, bass and SRS™ sound settings. Press the or Button to

adjust settings for best sound. When the SRS circuit is switched 'On' the SRS indicator will appear in the display.

8.To turn off the unit, press the Button. Your iPhone/iPod will continue charging while in the dock if unit is connected to AC power. It will not charge when running on internal battery.

Listening to FM Radio

Setting up the Antenna

Insert the FM Antenna plug into the Aux-in/FM Antenna Jack on the back of the unit. Extend the wire antenna fully for best reception. Do not strip, alter or attach to other antennas.

Tuning and Playing the FM Radio

1.Press the Radio/AUX Button as needed to turn the unit on and toggle between FM radio and aux-in modes. Select FM Radio mode. The last selected radio station will play and the frequency will appear in the display.

2.Press the or Button to tune radio to a desired station. Pressing and holding the or Button (2 sec. then release) will seek the next clear FM radio station.

3.Press the Volume or Button to adjust the volume setting.

4.If needed, move the radio mono/stereo switch located on back of the unit to mono to improve reception/signal.

5.To turn off the unit, press the Button. iPhone/iPod will continue charging while in the dock.

Setting and using FM Presets

You can set and save up to 6 radio station presets in memory.

1.To set a station as a preset, enter FM radio mode (see above).

2.Press the Presets Button as needed to step through the presets (1 - 6) to the desired preset number.

3.Press and hold the Presets Button until the display flashes, then press the or Button to tune to the desired station for the preset number (press and hold or briefly to scan to the next clear FM station).

4.Press the Presets Button to confirm your preset. To continue setting presets, follow steps 2-3 above).

9