Using The Remote Control Unit
The Remote Control controls basic functions on the iH7 and certain iPod® functions when the iPod® is docked in the iH7. For best results, use the remote control within 30 feet of the unit.
Turns iH7 ON or OFF | Power On/Off Alarm |
|
|
| Button .............. Skip to previous or next track when | |
or reset alarm when | Reset Button |
|
|
|
| iPod is playing, or HOLD to scan |
|
|
| Button | current playing track. In radio mode, | ||
alarm is sounding |
|
|
|
| ||
|
|
|
| press to tune stations. HOLD to scan | ||
|
|
|
|
|
| |
|
|
|
|
|
| radio stations. |
Selects iPod and | iPod Play/Pause Button |
|
|
| Volume _ Button | Lowers volume level |
plays track. In play |
|
|
|
| Volume + Button | Raises volume level |
|
|
|
| |||
mode , press to pause | Mute Button |
|
|
| EQ Button..............Set Treble, Bass and Balance | |
|
|
| ||||
Mutes volume |
|
|
|
| settings for best sound | |
Cycles through AM | Presets Select Button |
|
|
| Radio Button..........Selects Radio function, AM and | |
or FM radio presets |
|
|
|
| ||
|
|
|
|
| FM1 and FM2 radio bands | |
Snooze mode when | Snooze/Dimmer Button |
|
|
|
| |
|
|
|
|
|
alarm sounds, otherwise dims display
Install/Replace the Remote Control Batteries
The remote control batteries are already installed at the factory. When the remote control stops operating or its range seems reduced, replace the batteries with new ones.
1.The battery door is located on the back end of the unit.
2.Press to release the battery door latch.
3.Insert two “CR2032”
4.Replace the battery holder back in the remote control.
NOTE: PLEASE DISCARD BATTERIES PROPERLY
CHANGING THE REMOTE CONTROL CODE
Battery |
door |
DIP switches |
The iH7 has 4 DIP switches located in the backup battery compartment (see page 4) and in the remote control battery compartment. If you experience interference from other remotes or have more than one iH7 operating at once, you may need to change the DIP switch settings (DIP settings on remote and base unit must always match). To do so:
a)open the battery compartment on both the remote control and the iH7.
b)check that all DIP switch positions on unit and remote control match
c)use fingernail or small object such as a paperclip tip to move ONE of the switches on the unit to a different position. Do the same on the remote, making sure to move the same switch to the same position so the switches on each match.
d)turn the unit on AFTER changing the DIP switch position for the new code to take effect. If the DIP switch is changed while unit is on, turn unit off then back on.
e)test performance. If interference is still an issue, adjust DIP switch settings again.
5