iR70
Remote not included
with all iH70
models.
To order a remote,
please visit
www.ihomeaudio.com
Using the Optional Remote Control
Power Button turns unit ON and OFF
Volume Buttons raise and lower volume on the unit.
Pressing FWD/REV while iPod is inserted will FWD/REV to next/previous track
Pressing and holding FWD/REV while iPod is docked will scan forward/reverse within currently playing track.
Pressing Play/Pause from power off mode will play iPod.
Pressing Play/Pause while iPod is docked and playing will pause iPod.
Press again to resume play.
Pressing the up/down buttons for Bass and Treble, will raise or lower bass or treble
Pressing the 3D button will toggle the 3D effect on and off.
Pressing the reset button will reset Bass and Treble level to 0 and turn 3D effect off.
Pressing the mute button will mute unit. While unit is muted, LED will flash as long as unit is muted. Pressing mute again or pressing volume up or down will unmute.
The up, down, fwd, rev, menu, and enter buttons are used to navigate the iPod.
The shuffle and repeat buttons will activate/deactivate the iPod’s shuffle and repeat modes.
Install/Replace the Remote Control Battery
The remote control battery is already installed at the factory. When the remote control stops operating or its range seems reduced, it is time to replace the battery with a new one.
1. The battery compartment is located on the back end of the unit. 2. Slide the battery compartment door to release the battery door.
3. Remove the old battery and insert a CR2032 battery, checking that the + and – sides of the battery match the drawing on the battery door.
4. Replace the battery door on the remote control.
Note: Make sure you dispose of batteries properly (see your local regulations).
Battery Compartment
5
