iHome manual Replacing Clock Backup Battery, Replacing the RemoteUsingControlthe iHC5Battery

Replacing Clock Backup Battery

The iHC5 uses a backup battery system (3 pre-installed AA batteries) to provide continuous alarm operation and clock settings in the event of a power failure. If the backup battery has been installed and a power failure occurs or the AC cord is accidentally disconnected, the display backlight will not remain lit, but current time and alarm time settings will be temporarily maintained. Otherwise, you must reset the time and alarm settings.

NOTE: Please make sure the AC adaptor is connected. Otherwise all settings may be lost during battery replacement.

1.Open the backup battery compartment door located on the bottom of the unit.

2.Insert 3 AA batteries, checking that the polarity (+ and – ends of the battery) matches the drawing near the battery compartment.

3.Close the compartment door.

Replace Backup Battery
	


Note: Make sure you dispose of batteries properly (see your local regulations).

Replacing the RemoteUsingControlthe iHC5Battery

The remote control battery is already installed at the factory. When the remote control	Battery Door
stops operating or its range seems reduced, it is time to replace the battery.

1. The battery door is located on the back end of the remote.

2. Pull the battery door to release the battery door latch.

3. Insert a CR2032 battery, checking that the + and – sides of the battery match the drawing

inside the battery compartment. 4. Replace the battery door into the remote control.

Note: Make sure you dispose of batteries properly (see your local regulations).

For best results, aim remote control towards the remote sensor on the lower left corner of the display.

7