
IKELITE SINGLE CORD/
NIKONOS-STYLE #4104.6
SINGLE SYNC CORD #4104.6____________________________________
Connects a single (1) Ikelite Substrobe toa Nikonos IV, V, RS camera or suitable FILM camera housing that utilizes the
Nikonos Style
Connector
ONLY IKELITE TTL SUBSTROBES CAN BE CONNECTED.
DO NOT use the TTL cord on a non TTL strobe; you will damage the camera.
DO NOT remove the sync cord from the strobe or camera underwater or when wet. Connections are NOT waterproof when disconnected underwater.
DO NOT leave the cord connected for prolonged periods. Otherwise, the cord may freeze to the strobe or camera. After each dive, disconnect the cord and lightly lubricate the connector threads. Never use spray lubricant.
CONNECTING THE STROBE_____________________________________ | ||
1. | Make sure all components are dry. |
|
2. | Clean and lightly lubricate the stem | Stem O'ring |
3. | connector threads. Check the |
|
Note the positioning of the receptacles and pins. | Retaining | |
| Properly align the end of the sync cord and insert into | Ring |
4. | the strobe connector. |
|
| ||
5. | Push the connector body further into the strobe connector |
|
| and continue to tighten the Retaining ring. |
|
CONNECTING TO THE CAMERA OR HOUSING____________________ | ||
1. | Make sure all components are dry. Clean and lightly | Index Groove |
| lubricate the stem shaft, | Stem O'ring |
2. | Check the stem |
|
Align the index groove with the Indexing Pin of the flash |
| |
| socket, and insert the stem into the flash socket. | Red Retainer |
3. | Rotate the retaining ring counter clockwise until it | O'ring |
Retaining | ||
| mates with the flash socket threads. Then carefully | Ring |
| rotate retaining ring clockwise and thread it into the |
|
| flash socket until snug. |
|
LIMITED WARRANTY___________________________________________
All Ikelite products are warranted against any manufacturing defects for a period of one (1) year from the date of purchase. Defective products should be returned prepaid to Ikelite. Ikelite will, at its discretion, repair or replace such products, and will return to customer prepaid. All other claims,
of any nature, including but not limited to bulb failure are not covered. Except as mentioned above, no other warranty expressed or implied, applies to this Ikelite product.
IKELITE UNDERWATER SYSTEMS
50 West 33rd Street, P.O. Box 88100,
Indianapolis, IN 46208 USA
(317)