Iluv I177 Operational Instructions, Setting the Clock Time, Setting the Alarm Time

GETTING STARTED

Setting the Clock Time

1.To set the time, first locate theTIME SET button. Press and hold the TIME SET button down until the display begins to flash. Turn the SEARCH wheel to select 24HR or 12HR. Then press TIME SET button to confirm. Rotate theSEARCH wheel until the desired time is displayed.

Remember to choose the correct AM or PM setting.

Note: An icon to the right of the display indicates PM, but there is no AM indicator.

2.To secure the time setting, press the TIME SET button again to confirm.

3.To set the correct year, you may either rotate the SEARCH wheel until the present year is displayed or press the TIME SET button initially to accept the current setting. Press the TIME SET button again to secure year setting.

4.Once the first three steps are complete, the date display will be flashing in the lower right corner of the display. Press the TIME SET button to accept the current setting or turn the SEARCH wheel until the current date is displayed. Press the TIME SET button to secure date setting.

Setting the Alarm Time

This unit supports two alarm settings for dual alarm feature.

1.To set the Alarm, press and hold the ALARM 1 or the ALARM 2 button until the display begins to flash. Rotate the SEARCH wheel until the desired alarm time is displayed.

Note: Remember to choose the correct AM or PM setting, an icon to the right of the display indicates PM, but there is no AM indicator.

2.Press the WAKE TO button and select the option for desired alarm sound source: iPod, radio or buzzer.

3.Press the ALARM 1 or ALARM 2 button to pre-set the volume level when the Alarm(s) is (are) activated. Use the VOLUME wheel to adjust the volume level from 1 to 40. When the Alarm(s) is (are) activated, the volume will gradually rise from low to the pre-set setting.

4.Press the ALARM 1 or ALARM 2 buttons again to exit the alarm setting mode.

Notes:

•With the Alarm set, the i177 is now activated to wake you up. To ensure this setting, check to see if the alarm and wake icons appear on the display.

•Take notice of the adjusted volume level and make sure it is set at an appropriate level for waking up.

OPERATIONAL INSTRUCTIONS

IMPORTANT

1. Occasionally, files on iPod can become corrupted. This may cause an erratic behavior with your iLuv products. Apple recommends that you visit their website www.apple. com to obtain instructions on resetting or restoring your iPod to factory settings.

2.It is imperative that you use the correct dock adapter for your iPod and that the dock adapter fits appropriately into the built-in universal dock. Ignoring these rules can cause severe damage to your iPod. Please refer to the section “Installing the Dock Adapter” to properly install the dock adapter before operating the i177 with your iPod.

Outputting the Audio Signal to an External Amplifier or Recording Device

The i177 can output the audio signal to an external amplifier or recording device. To use this function, please follow the instructions below:

1.Connect the 3.5mm plug into the LINE-outjack on the rear of the i177. Connect the other end plug to the audio input jacks of the external amplifier or recording device.

2.Turn on the i177 and the external amplifier or recording device.

3.Place your iPod in the built-in universal dock, and change the mode to iPod.

Note: The line output is not affected by the volume setting on the i177. Please use the volume control of the external device to increase or decrease the volume level. But also beware that the audio signal of the i177 from its LINE-OUT t jack will be muted when the volume level is set to “0”.

8 iLuv i177 V14M14_IM_EN_09242008 iLuv 9