Iluv IMM173 Getting Started, Power Source, Protect your Furniture, Battery, door latch

Models: IMM173

1 15
Download 15 pages 9.04 Kb
Page 3
Image 3
GETTING STARTED

GETTING STARTED

Power Source

This system is designed to operate on AC100V~240V 60/50Hz house current only.

Connecting this system to any other power source may cause damage to the system and such damage is not covered by your warranty.

Main plug is used as the disconnect device, the disconnect device shall remain readily operable.

Note:

 

 

The system has an AC plug and will only fit into matching AC

 

 

outlets. This is a safety feature to reduce the possibility of electric

 

 

shock. If the plug will not fit in your AC outlets, you should have

 

 

the outlet changed by a qualified, licensed electrician. Do not use

 

 

an adapter to make the plug fit into your outlet. This defeats the

 

 

safety feature and could expose you to electric shock.

AC Plug

AC Oulet

 

Protect your Furniture

This model is equipped with non-skid rubber ‘feet’ to prevent the product from moving when you operate the controls. These ‘feet’ are made from non-migrating rubber material specially formulated to avoid leaving any marks or stains on your furniture. However certain types of oil based furniture polishes, wood preservatives, or cleaning sprays may cause the rubber ‘feet’ to soften, and leave marks or a rubber residue on the furniture. To prevent any damage to your furniture we strongly recommend that you purchase small self-adhesive felt pads, available at hardware stores and home improvement centers everywhere, and apply these pads to the bottom of the rubber ‘feet’ before you place the product on fine wooden furniture.

GETTING STARTED

Installing the Remote Control Battery

The remote control battery has been previously installed and ready for operation for the first time use. When the remote control stops functioning, replace the battery with a new one. To do so, locate the battery compartment and follow the steps below:

1.Slide out the battery holder from the remote control case.

2. Insert a “CR2025” 3V lithium battery making certain to follow the correct polarity. Observe the corresponding symbols (+/–).

3.Secure battery and push the battery holder back into the remote control until it is fully inserted.

 

A

Battery

B

door latch

 

3 iLuv

iMM173 V12M12_IM_EN_05082009

iLuv 4

Page 3
Image 3
Iluv IMM173 Getting Started, Power Source, Protect your Furniture, Installing the Remote Control Battery, door latch