Image 831.1597

Insertthe Barbell (35) throughthe locking Bar (34)

untilthe Barbell Is centered inthe Locking Bar.

9. Identify the Left Weight Glider (32) by looking at the

position of the round tube.

Press a 38ram Bushing (29) into each end of the

round tube on the Left Weight Glider (32).

Slide the Left Weight Glider (32) onto the left end of

the Barbell (35). Secure the Weight Glider to the

Barbell with a hand-tightened M8 x 16mm Screw (50).

Look at the drawing on page 4 to make sure that

you have correctly identified the left end. The Left

Weight Glider must be turned as shown in the

drawing.

29 32

Round tube

10. Identify the Right Weight Glider (31) by looking atthe

position of the round tube.

Press a 38mm Bushing (29) into each end of the

welded tube on the Right Weight Glider (31).

Slide the Right Weight Glider (31) onto the right end

of the Barbell (35). Secure the Weight Glider to the

Barbell with a hand-tightened M8 x 16mm Screw (50).

Make sure that the Weight Glider is turned as

shown in the drawing.

11. Note: If you are not planning to use Olympic weights

with the weight bench, you donot need toperform

this step. Keep the two Weight Adapters (33) in a

safe place incase youneed themin the future.

Slide aWeight Adapter (33) onto one end of the

Barbell (35). Using the allen wrench, secure the

Weight Adapter with an MIO x 25mm Bolt(43) and a

Large Washer (44). Note: The Large Washer must

fit into the indentation in the 50ram Bushing (47)

in the Weight Adapter.

Attach the other Weight Adapter (33) to the other end

of the Barbell (35) in the same manner•

10 o

33 47

44//"