7.Press the 20mm x 50mm Inner Cap (33) into the open end of the Seat Mounting Bracket (23).
Lubricate an M8 x 70mm Bolt (41). Attach the Seat Adjustment Bracket (36) to the indicated side of the Seat Mounting Bracket (23) with the Bolt and an M8 Nylon Locknut (42). Note: Do not over tighten the
Nylon Locknut; the Seat Adjustment Bracket must pivot easily.
8.Place the Seat Mounting Bracket (23) on the Bench Frame (5) so that the Seat Adjustment Bracket (36) fits over the welded pin on the side of the Bench Frame.
Lubricate an M10 x 80mm Bolt (31). Attach the Seat Mounting Bracket (23) to the indicated bracket on the Bench Frame (5) with the Bolt and an M10 Nylon Locknut (11). Note: Do not over tighten the
Nylon Locknut; the Seat Mounting Bracket must pivot easily.
9.Turn the Seat (14) as shown. Attach the wide end of the Seat to the bracket on the Seat Mounting Bracket (23) with two M6 x 16mm Screws (3).
Tilt the Seat Mounting Bracket (23) upwards and attach the narrow end of the Seat (14) to the Seat Mounting Bracket with an M6 x 35mm Bolt (34) and an M6 Washer (30).
10.Attach the Adjustable Bench Leg (2) to the Bench Leg (1) with the Adjustment Knob (37).
Insert a 45mm Square Inner Cap (40) into the top of the Adjustable Bench Leg (2).
7 | 41 |
|
|
|
|
| |
| 36 |
| 23 |
|
|
| |
| Lubricate |
|
|
|
|
| 42 |
| 33 |
|
|
8 |
|
|
|
| 23 |
|
|
| 36 |
|
|
| 31 |
|
|
Lubricate |
|
| |
| Welded |
|
|
| Pin |
|
|
|
| 5 | 11 |
|
|
| |
9 |
|
|
|
| 14 |
|
|
| Bracket |
|
|
| 23 |
|
|
| 30 |
|
|
| 3 |
|
|
| 34 |
|
|
10 | 40 |
|
|
|
|
| |
|
| 2 |
|
| 37 |
|
|
| 1 |
|
|
8
