12.Attach the upper end of one of the Weight Guides (53) to the bracket on the Upright (43) with an M8 x 30mm Bolt (64) and an M8 Washer (77).
Attach the other Weight Guide (53) to the other Upright (43) in the same manner.
Tighten all of the Locknuts used in steps 1 to 12.
13.Press a 50mm x 70mm Outer Cap (10) onto each end of the Stabilizer (13).
Attach the Stabilizer (13) to the Bench Frame (5) with two M10 x 60mm Button Head Bolts (12) and two M10 Nylon Locknuts (11). Note: There is an indentation around each hole on one side of the Stabilizer; this side must be facing the floor so that the warning decal is in the position shown.
Note: Do not tighten the Nylon Locknuts yet.
14.Press a 50mm Square Outer Cap (20) onto each end of the Bench Base (7).
Attach the Bench Base Joint Plate (19) to the Bench Base (7) with two M10 x 70mm Bolts (21), two M10 Washers (6), and two M10 Nylon Locknuts (11).
Attach the Bench Leg (1) to the Bench Base Joint Plate (19) with two M10 x 70mm Bolts (21), two M10 Washers (6), and two M10 Nylon Locknuts (11).
Be sure the welded nut is in the position shown. Note: Do not tighten the Nylon Locknuts yet.
15.Attach the Bench Leg (1) to the Bench Frame (5) with two Bench Joint Plates (18), four M10 x 70mm Bolts (21), and four M10 Nylon Locknuts (11).
Note: Tighten all the M10 Nylon Locknuts (11) used in steps
12 |
|
|
| 64 |
|
|
|
| |
|
|
|
| 77 |
|
| 53 |
| 43 |
|
|
|
| |
13 |
|
|
| 11 |
|
|
|
| |
|
|
|
| 13 |
| 5 | 10 |
| Decal |
|
|
| ||
|
|
|
| 12 |
|
|
|
| 10 |
14 |
|
|
| Welded Nut |
|
|
| 6 | 1 |
|
|
|
| |
| 21 |
|
| 11 |
| 7 |
| 6 | |
|
|
| ||
20 | 6 |
|
| 19 |
| 21 |
| 6 |
|
|
|
|
| |
|
|
| 20 |
|
15 | 21 |
|
|
|
|
| 18 |
| |
|
|
|
| |
|
|
|
| 5 |
|
|
|
| 18 |
|
|
| 1 | 11 |
|
|
|
|
10
