Image IMBE53991 user manual Guide away from the Upright 1 as you insert it, Locknut yet

8.Press a 25mm Bushing (48) into each end of the Locking Bar (34).

Insert the Barbell (35) through the Locking Bar (34) until the Barbell is centered in the Locking Bar.

8

48

34

35 48

9.Identify the Left Weight Glider (32) by looking at the position of the round tube.

Press a 38mm Bushing (29) into each end of the round tube on the Left Weight Glider (32).

Slide the Left Weight Glider (32) onto the left end of the Barbell (35). Secure the Weight Glider to the Barbell with a hand-tightened M8 x 20mm Screw (50).

Look at the drawing on page 4 to make sure that you have correctly identified the left end. The Left Weight Glider must be turned as shown in the drawing.

9

29 32

35 50

29

Round tube

10.Identify the Right Weight Glider (31) by looking at the position of the round tube.

Press a 38mm Bushing (29) into each end of the welded tube on the Right Weight Glider (31).

Slide the Right Weight Glider (31) onto the right end of the Barbell (35). Secure the Weight Glider to the Barbell with a hand-tightened M8 x 20mm Screw (50).

Make sure that the Weight Glider is turned as shown in the drawing.

11.Identify the Left Safety Spotter (24) by the position of the handle and the Left Spotter Hook (65). Place the Left Safety Spotter on the left Base (7) so it is cen- tered over the indicated hole.

Have a second person hold the Locking Bar (34) so that the Left Weight Glider (32) rests on top of the Left Safety Spotter (24). Insert a Weight Guide (18) into the Left Weight Glider, the Left Safety Spotter, and the hole in the Base (7). Note: Tilt the Weight

Guide away from the Upright (1) as you insert it.

Attach the Weight Guide (18) to the Base (7) with an M8 x 60mm Bolt (39), two M8 Washers (52), and an M8 Nylon Locknut (54). Do not tighten the Nylon

Locknut yet.

10
29		50
		29
Round	31	35
tube
11	18
		1
34
	32
Handle
	24	65
		7
54
		Hole
52
		39

9