3.Refer to the inset drawing. Set a Filter Gasket (33) on top of the Filter (16). Next, press the Filter Cover
(8) into the spa until it is fully seated. Then, tighten the Locking Ring (19) onto the spa.
Remove the two warning decals (not shown) from the spa shell. Using a damp cloth, wipe the spa shell clean. Before filling the spa, make sure that it is in the desired position and that there is room to easily service the spa. Once the spa is filled, it will have to be drained before it can be moved.
Turn the Air Vent (29) counterclockwise to open it. Using a garden hose or other clean water source, begin filling spa. Do not use soft water. The spa may be filled with cold water; however, if warm or hot water is used, the spa will be ready for use sooner. Fill the spa until the water is at the level shown at the right. Do not overfill the spa.
Turn the Air Vent (29) clockwise to close it.
4.Attach the nozzle of the included air pump to the valves on the Inflatable Cover (4). Fill the Inflatable Cover with air. Do not overfill the Inflatable Cover.
Slide one of the straps on the inside of the Spa Cover (11) through one of the loops on the Inflatable Cover (4). Attach the latch on the strap to the buckle on the other end of the strap. Make sure that the cutout in the Inflatable Cover is lined up with the warning label on the Spa Cover. Attach the other three straps on the inside of the Spa Cover through the loops on the Inflatable Cover in the same way. Place the Spa Cover over the spa and line up the cutout in the Inflatable Cover with the Console (not shown).
5.Pull down one of the straps on the Spa Cover (11) and hold the Buckle (30) against one of the wood panels on the spa. (Note: To position the Buckle cor- rectly, have a second person hold the strap on the opposite side of the Spa Cover tight.) The Spa
Cover must be tight. Do not place the Buckle over the grooves between the wood panels. Refer to the inset drawing. Remove the latch from the Buckle (30). Attach the Buckle to the wood panel with two #4 x 3/4Ó Screws (31). Note: It may be helpful to use a drill with a 1/16Ó bit to make starter holes in the wood panel. It may also be helpful to apply a little soap or wax to the screw threads.
Attach the other five Buckles (30) to the wood panels in the same way.
Remove the Spa Cover (11) and the Inflatable Cover (not shown) from the spa.
3 | 19 |
|
8
33
Fill to Here |
| 16 |
| |
|
|
|
|
|
|
|
|
|
|
| 29 |
4 | 4 |
| |
| Loop |
| Cutout |
| Buckle |
Strap | |
| Latch |
| 11 |
| Warning |
| Label |
5 | 11 |
| |
| Strap |
| Latch |
| 30 |
| 31 |
| Strap |
| 30 |
9
