Using the Controls
Air Control |
|
|
| |
Diverter | Jet | Light | Temperature | |
Button | Button | Buttons | ||
|
Refer to the diagram above. The function of each control is explained below:
Air Control: Determines the amount of air flowing through the hydrotherapy jets during operation. If the control is turned counterclockwise, the amount of air flowing through the jets will increase. If the control is turned clockwise, the amount of air will decrease.
Diverter: Controls the flow of water through the hydrotherapy jets and the whirlpool jet. When the diverter is turned fully clockwise, the flow will be through the whirlpool jet; when the diverter is turned fully counterclockwise, the flow will be through the hydrotherapy jets; when the diverter is halfway between the clockwise and counterclockwise posi- tions, the flow will be evenly distributed through the whirlpool jet and the hydrotherapy jets.
Jet Button: Turns the spa jets on and off. If the but- ton is pressed once, the spa jets will run at low speed, providing gentle hydrotherapy. If the button is pressed again, the jets will run at high speed, providing more intense hydrotherapy. If the button is pressed a third time, the jets will shut off.
The spa also features an automatic mode that heats and filters the water when the spa is left unattended. When the spa is first plugged in, or if the buttons on the console have not been pressed for longer than twenty minutes, the automatic mode will begin filtering or heating the water as needed. Note: To keep the filter and heat cycles from running, the power cord must be unplugged.
Light Button: Turns the underwater light on and off.
Temperature Buttons: Control the temperature setting of the water. The temperature can be set at 70¡F to 104¡F. The water heats at about 1.8¡F per hour with the cover on. Use a medical or other accurate ther- mometer to check the temperature of the water. Note: The word ÒCOOLÓ will appear in the console display if the temperature of the water is more than 20¡F cooler than the set temperature. When this happens, the heater will automatically activate to warm the water. The word ÒICEÓ will appear in the display if the tem- perature drops below 40¡F. If this happens, the pump will automatically circulate the water and warm the plumbing to keep the water from freezing.
The temperature buttons can also be used to change the filter cycle time. First, press either of the tempera- ture buttons. While the console display is flashing, press the jet button. The letters ÒFCÓ should appear in the display. Next, press the temperature buttons to select a
12
