Image Imsw20701, Imsg20701, Imsb20701 Symptom The Water Pulsates Or There Is Minimum Water Flow

Models: Imsw20701, Imsg20701, Imsb20701 IMSG20701, IMSW20701, IMSB20701

1 20
Download 20 pages 52.56 Kb
Page 17
Image 17

8.SYMPTOM: THE WATER PULSATES OR THERE IS MINIMUM WATER FLOW

a.This usually occurs only when the water level is low. Add water to the level shown in step 3 on page 8.

b.The filter may be dirty. Check the filter and clean it if necessary.

9.SYMPTOM: THE WATER IS NOT BEING CLEANED BY THE FILTER

a.Check to see if the filter is in place. Clean the filter if it is dirty.

b.Check the chemical balance of the water. If the pH is incorrect, the sanitizing agents will not function properly.

10.SYMPTOM: THE WATER LEVEL DROPS

a.Some water loss due to evaporation is normal. If rapid water loss occurs, or if you notice wet-

ness on the floor around the RENEW 207, the spa shell may have a leak. Contact your local spa and pool service provider for repairs.

b. A clamp or seal inside the pump compartment may be loose. Check inside the pump compart- ment for excess water, and watch the pump unit while it is operating to see if water drips from any of the plumbing. If you can identify the location of the leak inside the spa jet unit, tight- en the clamp or replace the damaged seal.

11.SYMPTOM: NO AIR FLOWS THROUGH THE ADJUSTABLE HYDROTHERAPY JETS WHEN THE AIR CONTROL IS TURNED COUNTER- CLOCKWISE

a.The three adjustable thera-jets can be closed and opened by pushing and pulling the noz- zles. If no air flows through the thera-jets when the air control is turned counterclockwise, sim- ply pull the nozzles slightly.

17

Page 17
Image 17
Image Imsw20701, Imsg20701, Imsb20701 user manual Symptom The Water Pulsates Or There Is Minimum Water Flow