TROUBLESHOOTING
Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, please call the
PROBLEM: The power does not turn on
SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor is plugged into a properly grounded outlet (see page 9). Use only a
b. After the power cord has been plugged in, make sure that the key is inserted into the console.
c.Check the reset/off circuit breaker located on the treadmill frame near the power cord. If the switch protrudes as shown, the circuit breaker has tripped. To reset the circuit breaker, wait for five minutes, and then press the switch back in.
PROBLEM: The power turns off during use
c
Tripped 
Reset
SOLUTION: a. Check the reset/off circuit breaker (see the drawing above). If the circuit breaker has tripped, wait for five minutes and then press the switch back in.
b.Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for five minutes, and then plug it back in.
c.Remove the key from the console. Reinsert the key fully into the console.
d.If the treadmill still will not run, please see the front cover of this manual.
PROBLEM: The incline of the treadmill does not change correctly
SOLUTION: a. With the key in the console, press one of the Incline buttons. While the incline is changing, re- move the key. After a few seconds,
PROBLEM: The displays of the console do not function properly
SOLUTION: a. Remove the key from the console and UNPLUG THE | a | 44 | |
POWER CORD. With the help of a second person, | |||
|
| ||
carefully tip the Uprights (97) down as shown. Remove |
|
| |
the three Hood Screws (44) and two Screws (108). |
|
| |
Note: A phillips screwdriver with at least a 5” shaft is |
|
| |
required. |
|
| |
|
| 108 | |
|
| 97 | |
|
| 108 |
26
