Image IMTL09905.0

PROBLEM SOLUTION

a. If the walking belt is off-center, first remove

the key and UNPLUG THE POWER

CORD.If the walking belt has shifted to

the left, use the allen wrench to turn the

left rear roller bolt clockwise 1/2 of a turn; if

the walking belt has shifted to the right,

turn the bolt counterclockwise 1/2 of a turn.

Be careful not to overtighten the walking

belt. Then, plug in the power cord, insert

the key, and run the treadmill for a few min-

utes. Repeat until the walking belt is centered.

b. If the walking belt slips when walked on,

first remove the key and UNPLUG THE

POWER CORD.Using the allen wrench,

turn both rear roller bolts clockwise 1/4 of a

turn. When the walking belt is correctly

tightened, you should be able to lift each

edge of the walking belt 3 to 4 inches off

the walking platform. Be careful to keep

the walking belt centered. Then, plug in the

power cord, insert the key, and walk on the

treadmill for a few minutes. Repeat until the walking belt is properly tightened.

a. Remove the key from the console and UN-

PLUG THE POWER CORD.Next, remove

the screws from the hood and carefully re-

move the hood. Locate the Reed Switch

(17) and the Magnet (12) on the left side of

the Pulley (11). Turn the Pulley until the

Magnet is aligned with the Reed Switch.

Make sure that the gap between the

Magnet and the Reed Switch is about

1/8”. If necessary, loosen the indicated

Screw (44), move the Reed Switch slightly, and then retighten the Screw. Re-at-

tach the hood and run the treadmill for a few minutes to check for a correct speed

reading.

4. The walking belt

isoff-center or

slips when

walked on

5. The displays of the

console do not

function properly 12

Top

View

1/8”