ASSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench
and your own wire cutters 
(not included).
Note: The underside of the treadmill walking belt is coated with
1.With the help of a second person, carefully raise the Uprights (80) until the treadmill is in the position shown.
2.Cut any plastic ties from the Right and Left Handrails (93, 94). Set the Right Handrail (the longer Handrail) on the right Upright (80). Finger tighten a Short Handrail Bolt (59) with one of the two metal Handrail Washer (95) into the Upright and the Right Handrail. Do not tighten the
Handrail Bolt yet.
Attach the Left Handrail (94) as described above.
3.Insert a Long Handrail Bolt (37) with one of the four Washers (60) and a Plastic Washer (53) into the lower end of the Right Handrail (93). Finger tighten the Long Handrail Bolt into the Frame (87).
Next, hold an Upright Spacer (11) inside the lower end of the right Upright (80). Insert an Upright Bolt (7) with a Washer (60) through the Upright and the Upright Spacer, and finger tighten the Upright Bolt into the Frame (87).
Repeat this step on the left side of the treadmill (not shown).
Tighten the three Bolts (7, 37) on each side. Tighten the two Short Handrail Bolts (59) shown in step 2.
1 |
|
|
|
|
|
| 80 |
|
|
2 |
|
|
|
|
94 | 95 | 59 |
|
|
|
|
| 93 | 59 |
|
|
| 95 | |
|
|
|
| 80 |
3 |
|
|
|
|
|
| 80 |
|
|
|
| 93 |
|
|
|
|
|
| 7 |
|
| 11 | 60 | 7 |
|
| 87 |
|
|
|
| 60 |
|
|
53 |
| 37 |
|
|
4.Make sure that all parts are tightened before you use the treadmill. Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see pages 12 and 13). To protect the floor or carpet from damage, place a mat under the treadmill.
5
