Image IMTL4153.1 specification

2.Open part bag C. See drawing 2a. Locate the Wheel Housings (106). Attach a Wheel (108) to each Wheel Housing with a Wheel Bolt (107) and a Wheel Nut (21) as shown. Do not overtighten the Wheel Bolts.

See drawing 2b. Insert a Wheel Housing (106) into the Base (109). (Note: It may be helpful to use a rubber mallet to fully insert the Wheel Housing.) Press a Base Endcap (99) onto the end of the Base.

Repeat this step on the opposite side of the treadmill.

3.With the help of a second person, carefully tip the Uprights (69, 82) down so the treadmill pivots on the Wheels (108) as shown.

Tighten a 3/4” Screw (6) into one side of the Base (109) and one of the Wheel Housings (106). Attach a long Rear Base Pad (105) and a short Front Base Pad (100) to the Base with four additional 3/4” Screws (6) as shown.

Repeat this step on the opposite side of the treadmill.

With the help of a second person, carefully raise the Uprights (69, 82) to the vertical position.

4.With the help of a second person, hold the Console Base (85) near the Uprights (69, 82) as shown.

Connect the Wire Harness (83) to the wire harness in the Right Handrail Bracket (113). Make sure to connect the connectors properly (see the inset drawing). The connectors should slide together easily and snap into place. If the connectors do not slide together easily and snap into place, turn one connector and try to con- nect them again. IF THE CONNECTORS ARE NOT

CONNECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. Insert the wires harnesses into the Right Upright (82).

Open part bag A. Hold the Handrail Brackets (73, 113) on top of the Uprights (69, 82). Finger tighten two 1” Bolts (71) with 5/16” Star Washers (127) into the Handrail Brackets and the tops of the Uprights as shown. Press the Handrail Brackets towards the cen- ter of the treadmill. Then, tighten both Bolts.

2a	106		106
107
		21	107
	108		108
			108
2b			99
			99
			99
		106
3
	69		6
	69
82			100
82	100
	100		109
			109
		6	105
			106
		109	6
			108
	6	105
106		6
		6
	108
4
71
127
	73
		85
		69	71
		69
		127
			83
			113
		83	82
		83

Image IMTL4153.1 user manual Repeat this step on the opposite side of the treadmill

Models: IMTL4153.1

Repeat this step on the opposite side of the treadmill.

Repeat this step on the opposite side of the treadmill.

2a	106		106
107
		21	107
	108		108
			108
2b			99
			99
			99
		106
3
	69		6
	69
82			100
82	100
	100		109
			109
		6	105
			106
		109	6
			108
	6	105
106		6
		6
	108
4
71
127
	73
		85
		69	71
		69
		127
			83
			113
		83	82
		83

2a	106		106
107
		21	107
	108		108
			108
2b			99
			99
			99
		106
3
	69		6
	69
82			100
82	100
	100		109
			109
		6	105
			106
		109	6
			108
	6	105
106		6
		6
	108
4
71
127
	73
		85
		69	71
		69
		127
			83
			113
		83	82
		83

2a	106		106
107
		21	107
	108		108
			108
2b			99
			99
			99
		106
3
	69		6
	69
82			100
82	100
	100		109
			109
		6	105
			106
		109	6
			108
	6	105
106		6
		6
	108
4
71
127
	73
		85
		69	71
		69
		127
			83
			113
		83	82
		83