ASSEMBLY

To hire an authorized service technician to assemble the treadmill, call toll-free 1-800-445-2480.

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill perfor- mance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Assembly requires the included allen wrenches

and your own phillips screwdriver

 

wire cutters

, rubber mallet

, and adjustable wrench

.

For help identifying the assembly hardware, refer to the drawings below. Note: The assembly hardware and other small parts are packaged in separate part bags. Do not open the part bags until instructed to do so. (The part bags are not labeled according to the order in which they are to be opened.) If a part is not found in the part bags, check to see if the part has been preassembled.

3/4” Screw (6)–16

1 1/4” Screw (92)–2

2” Silver Screw (93)–2

1 1/4” Bolt (104)–4

 

Wheel Bolt (107)–2

1” Bolt (71)–2

Wheel Nut (21)–2

Internal Star

5/16” Star

 

 

 

Washer (72)–4

Washer (127)–2

1. Open part bag B. Identify the Right Upright (82) (the

1

 

Left Upright [69] has a large round hole in the location

 

 

 

shown). Lay the Right Upright flat. Cut the plastic ties off

 

83

the lower end of the Right Upright. Next, feed the Wire

 

82

Harness (83) into the bottom of the Right Upright and

 

pull it out of the hole in the top. Note: There may be a tie

 

69

on the end of the Wire Harness to help you pull it

 

 

 

through the hole.

 

 

Attach the Right Upright (82) to the bracket on the right

 

Bracket

side of the Base (109) with two 1 1/4” Bolts (104) and

 

 

two Internal Star Washers (72). (Note: It may be helpful

Hole

72

to use a rubber mallet to fully insert the Right Upright

 

104

into the bracket.) Do not tighten the Bolts yet. Be

 

careful not to damage the Wire Harness.

 

 

Attach the Left Upright (69) to the left side of the

 

109

 

 

Base (109) in the same way. Note: There is not a wire

 

 

harness on the left side.

 

 

6

Page 6
Image 6
Image IMTL4153.1 user manual Assembly, Base 109 in the same way. Note There is not a wire