Installing the PD-Switch
The PD-Switch is ready to use. Simply connect the appropriate data cables to ports 2 and up. Then connect the powered Ethernet cable to Port 1 (PD).
Wallmount Installation
The PD-Switch includes two X-shaped Wallmount holes in the enclosure. These holes accommodate the use of screws to flushmount the PD-Switch to a wall.
Wall-Mounting
Holes
DIN Rail Mounting
The PD-Switch can be mounted with two DIN Rail clips, a hardware option available through IMC Networks. The DIN Rail clips include screws, to allow the installation onto a DIN Rail. Install the screws into DIN Rail clips, which should be mounted perpendicular to the DIN Rail. Snap the converter onto the clips. To remove the converter from the DIN Rail, use a flat-head screwdriver into the slot to gently pry the converter from the rail. The DIN rail clips can be installed either on the bottom of the PD-Switch or on the side.
NOTE
When using the side-installed location, remove the countersunk screw from the enclosure, and then use the vacated hole for one of the DIN clip screws.
