STEP 4 (See Diagram 4)
A.) | Insert the Leg Developer Holder (#41) into the opening on the Front Stabilizer (#40). |
| Secure it with the Lock Knob (#6). |
B.) | Attach the Leg Developer (#38) to the bracket on the Leg Developer Holder (#41). Secure |
| it with a M12 x 2 3/8” Axle (#36) and M12 Allen Bolt (#45). |
C.) | Secure the Leg Developer (#38) with a 4” Lock Pin (#36). Remove the Pin when using the |
| Leg Developer. |
D.) | Insert a Foam Roll Tube (#32) halfway through the hole on the Leg Developer Holder |
| (#41). Insert two Foam Roll Tubes (#32) halfway through the holes on the Leg Developer |
| (#38). |
E.) | Push six Foam Rolls (#33) onto the Tubes from both sides. Plug six Foam Roll End Caps |
| (#34) to the ends. |
F.) | Attach the Olympic Sleeve (#5) onto the weight post on the Leg Developer. Attach the |
| Spring Clip (#44) onto the Olympic Sleeve. |
| DIAGRAM 4 |
7
