STEP 14 High-Low Station Cable Looping (See Diagram 14)
A.) | Slide a Ball Stopper (#70) onto the 262” |
| Strap Bracket (#45) onto the Cable. Secure the Bracket with a M8 x 1 ¼” Allen Bolt (#110) |
| and M8 Aircraft Nut (#124). |
B.) | Attach the Cable in between the |
| Sliding Pulley Frame (#22). Note: The Ball Stopper should be in front of the Sliding |
| Pulley Frame. |
C.) | Draw the Cable through the Sliding Pulley Frame then pull upward to the Pulley on |
| the top opening of the Sliding Pulley Vertical Beam (#9). |
D.) | Draw the Cable over the Pulley then pull forward to the Pulley on the rear opening on |
| the Upper Frame (#5). |
E.) | Draw the Cable over the Pulley then pull downward. Attach the Cable to the Pulley |
| on the Single Floating Pulley Bracket (#23) installed in Step12. |
F.) | Draw the Cable underneath the Pulley then pull upward to the Pulley on the upper |
| Rear Vertical Frame (#4). Let the Single Floating Pulley Bracket hanging for now. |
G.) Draw the Cable around the Pulley then drop the Cable inside the tube downward | |
| through the Rear Vertical Frame to the Pulley on the bottom opening. Remove the |
| Pulley to get the Cable out then reinstall the Pulley. Draw the Cable underneath the |
| Pulley then pull upward to the bracket on the Sliding Pulley Frame (#21). |
H.) | Attach the Cable head to the bracket. Secure the Cable head in place with one M10 |
| x 1 1/8” Allen Bolt (#99) and M10 Aircraft Nut (#125). |
I.) | Connect the Single Handle (#35) to the Cable Strap Bracket (#45) with a Hook (#41). |
21