STEP 4 (See Diagram 4)

A.) Insert two M10 x 2 3/8” Carriage Bolts (#56) all the way through the holes on the Leg Developer Holder (#5), then insert the two Bolts through the holes on the Main Seat Support (#4). Attach the Leg Developer Holder to the Main Seat Support. Secure them with the two M10 x 2 3/8” Carriage Bolts, one 4 ¾” x 2” Bracket (#45), two Ø ¾” Washers (#64), and two M10 Aircraft Nuts (#67). Thread a M18 x Ø 5/8” Lock Knob (#47) into the nut on the Leg Developer Holder.

B.) Attach the Leg Developer (#13) to the Leg Developer Holder. Secure it with one M10 x 3 ½” Allen Bolt (#57), two ¾” Washers (#64), and one M10 Aircraft Nut (#67).

C.) Insert two Foam Tubes (#18) halfway through the holes on the Leg Developer. Push four Foam Rolls (#37) onto the Tubes from both ends. Plug four Foam Roll End Caps (#43) into the ends.

D.) Slide an Olympic Sleeve (#44) onto the weight post on the Leg Developer. Attach a Spring Clip (#48) to the Sleeve.

E.) Attach the Arm Curl Handle (#30) to the back holes on the Leg Developer. Secure it with one 3” Lock Pin (#35). Attach the Abdominal Strap (#31) to the front holes on the Leg Developer. Secure it with another 3” Lock Pin.

DIAGRAM 4

9

Page 10
Image 10
Impex MD-8861 manual Diagram