Impex SB 660 manual Assembly Instruction

ASSEMBLY INSTRUCTION

Tools Required Assembling the Machine: One Adjustable Wrench and Allen Wrench

NOTE: It is strongly recommended two or more people assembling the machine to avoid possible injury.

STEP 1 (See Explode Diagram)

A.) Attach each end of the Main Frame (#1) onto the Stabilizers (#2). Secure each end with two M10 x 5/8” Allen Bolts (#8) and Ø ¾” Washers (#13) from the bottom of the Stabilizers.

B.) Attach the Dumbbell Frames (#3) to both sides of the Main Frame (#1). Align the holes and secure them with two M10 x 5 ¼” Allen Bolts (#9), four Ø ¾” Washers (#13), and two M10 Aircraft Nuts (#12).

C.) Attach two L-shaped Brackets (#4) to the holes on the Main Frame (#1). Secure the Brackets with one M10 x 4” Allen Bolt (#10), two Ø ¾” Washers (#13), and one M10 Aircraft Nut (#12). Repeat the same procedure to install the other brackets. Do not tighten the brackets yet.

D.) Place the Seat Pad (#5) onto the Main Frame. Align the holes to the Brackets. Secure it with six M8 x ¾” Allen Bolts (#11) and Ø 5/8” Washers (#14). Secure all Nuts and Bolts previously installed.

EXPLODED DIAGRAM

4