STEP 3 (See Diagram 3)
A.) | Attach the Backrest Incline Support (#12) in between the two |
| Backrest Supports (#17). Attach the Backrest Supports to the pivot on the Main Seat |
| Support (#4). Secure it with one M12 x 7 ½” Allen Bolt (#53), two ∅ 1” Washers (#60), |
| and one M12 Aircraft Nut (#45). |
B.) | Place the other end of Backrest Supports rest against the Backrest Adjustment Bar. |
C.) | Place the Backrest Board (#21) onto the Backrest Supports (#17). Secure it with four |
| M8 x 1 5/8” Allen Bolts (#54) and Ø 5/8” Washers (#58). |
D.) | Attach the Leg Developer (#6) to the Leg Developer Holder (#5). Secure it with one |
| Axle (#28), two M10 x 1” Allen Bolts (#52), and two Ø ¾” Washers (#59). |
E.) | Insert two Foam Tubes (#18) halfway through the holes on the Leg Developer. Push |
| four Vinyl Foam Rolls (#32) onto the Tubes. Push four Foam Roll End Caps (#39) into |
| the Tubes from both ends. |
F.) | Attach a Short Olympic Sleeve (#34) to the weight post on the Leg Developer. Attach a |
| Spring Clip (#27) to the Sleeve. |
G.) | Attach the Curl Bar Handle (#9) to the bracket on the Leg Developer. Secure it with a |
| |
H.) | Attach the Arm Curl Pad (#20) to the Arm Curl Stand (#7). Secure it with two M8 x 5/8” |
| Allen Bolts (#55) and Ø 5/8” Washers (#58). Insert the Arm Curl Stand into the opening |
| on top of Leg Developer Holder. Secure it with the Lock Knob. |
I.) | Remove the Arm Curl Stand and Curl Bar Handle when doing Leg exercises. |
9
