STEP 3 | (SEE DIAGRAM 3) | |
A.) | Attach a ∅ ¾” Washer (#3) onto a M10 x 6 ¼” Hex Bolt (#54). Insert the Bolt through | |
| the Butterfly (#17). Place a M10 Regular Nut (#57) onto the Bolt. Then insert the Bolt | |
| through the hole on the Rear Upright Beam (#1). Secure the Bolt with a Lock Knob (#8) | |
| behind the Upright Beam. Repeat the same step to install the other Butterfly. | |
B.) | Attach the Right Butterfly Handle (#56) to the Right Butterfly (#17). Secure it with a M10 | |
| x 2 ½” Carriage Bolt (#16), ∅ ¾” Washer (#3), and M10 Aircraft Nut (#4). Repeat the | |
| same step to install the other side. | |
C.) | Attach the Leg Developer (#38) onto the bracket on the Front Stabilizer (#42). Secure it | |
| with a Hex Socket Axle (#44) and Hex Socket Screw (#45). | |
D.) | Insert two Foam Roll Tubes (#39) halfway through the hole on the Leg Developer (#38). | |
| Push four Foam Rolls (#37) onto the tube from both sides. | |
E.) | Place three Spring Clips (#34) onto the post on the Leg Developer and Butterfly. | |
DIAGRAM 3
6
