GB | DOOR REVERSAL |
|
|
| |
| Warning: Before attempting to remove the doors, switch off the electrical supply and pull out the mains plug. | ||||
| It is recommended that you remove any loose items/fittings from inside the appliance and place food into insulated | ||||
| containers whilst carrying out this operation. |
|
| ||
| You may require assistance to carefully lay the appliance onto its back onto suitable protective materials (i.e. original | ||||
| packaging). |
|
|
| |
| Remove the doors |
|
|
| |
| 1. | Lay down the appliance on its back. |
|
| |
| 2. | Unscrew, remove and retain the bottom hinge. |
| ||
| 3. | Slightly open the bottom door and slide downward remove and carefully place to one side | |||
| 4. | Remove centre hinge and spacer if fitted. Slightly open the top door and slide downwards, remove and carefully | |||
|
| place to one side. |
|
|
|
| 5. | Unscrew and remove the top front cover from the cabinet . |
| ||
| 6. | Unscrew and remove the hinge pin and the bolt from the top right hand and refit them into the hole in the left hand | |||
|
| side. Refit the top front |
|
|
|
|
| cover. |
|
| 4 |
| 7. | Use a thin blunt instrument | 5 |
| |
|
| to remove the top and |
| 3 | |
|
| bottom hinge bushes and |
| ||
|
|
|
|
| |
|
| blanking plugs from the |
|
|
|
|
| doors, take care not to |
|
|
|
|
| mark the door handle. |
|
|
|
|
| Reposition the blanking |
|
| 2 |
|
| plugs and bushes on the |
|
| |
|
| opposite side. |
|
| 1 |
| 8. | Fit the blanking plugs |
|
| |
|
| provided into the right |
|
| 8 |
|
| hand two centre hinge |
| 6 | |
|
| holes. |
| ||
|
| |
|
| 7 |
Replacing the doors |
| |
1. | Slide the top door upwards and locate the top hinge pin into the door brush. Reposition the centre hinge on the | |
| opposite side. |
|
2. | Carefully slide bottom door upward | 1 |
| into the centre hinge pin. | |
3. | Unscrew the bottom hinge pin and | 2 |
| refit it on the opposite side.. |
|
4. | Fit the bottom hinge making sure that |
|
| the door is aligned to the cabinet. |
|
5. | Carefully stand the appliance upright | 3 |
| in it’s required location and make | |
| sure it is sitting level on the floor. |
|
| Open and close the doors checking |
|
| that the gasket makes a good seal |
|
| without any gaps when the doors are |
|
| closed. |
|
Note: Replace loose items/fittings back into the appliance and leave for at least 15 minutes before switching back on.
4
