Turning on the Appliance
Starting a wash cycle....
1.Make sure that the plug for the appliance is inserted into the wall socket.
2.Make sure that the water supply is turned on to full pressure.
3.Load the dishwasher (see the section entitled, "Loading the Dishwasher").
4.Pour in the detergent (see the section entitled, "Salt, Detergent and Rinse Aid").
5.Turn the knob located on the right of the control panel in the clockwise direction until the number or symbol for the cycle setting is aligned with the reference mark (see the section entitled, "Wash Cycle Table").
6.Press the
Cancelling or modifying a wash cycle setting...
Premise: A cycle that is underway can only be modified if it has only been running for a short time. Otherwise, the detergent
If you forget to load some of the dishes...
The wash cycle can be interrupted by pressing the
At the end of the wash cycle...
When the knob stops turning and is aligned with a STOP mark (see figure), the cycle has finished. Turn off the appliance using the
Wait a few minutes before unloading the dishwasher to avoid handling the dishes and utensils while they are still hot and more susceptible to breakage. They will also dry better.
1
may have already been used, and the appliance may have already drained the wash water. If this is the case, the detergent dispenser must be refilled (see the paragraph entitled, "Loading the
4
3
2
Detergent").
Press the
STOP
GB | 6 |
