How to use your dryer
1.Plug in, switch on electricity.
WARNING: WHEN SWITCHING ON OR OFF, PLEASE ENSURE THAT YOUR HANDS ARE DRY
2.Sort your laun- dry (see section “Sorting Your Laundry”)
3.Open the door by pressing and releasing the front panel in the position shown.
4.Always check the following:
FLUFF FILTER
is clean and in place
WATER CONTAINER is empty and in place
CONDENSER
is clean and in place
5.Load the dryer placing the clothes carefully in the drum pushing them well towards the back and away from the door seal. Close the door.
6. Select the rele- | 7. Select the |
vant heat setting | required programme |
(see section “The | or drying time. (see |
Controls”) | section “The |
| Controls”) |
8.Press the START switch to commence the drying pro- gramme.
9.When finished open the door and take out the laun- dry. Clean and replace the fluff fil- ter, and empty the water container.
10.Switch off elec- tricity and remove plug from socket.
WARNING: WHEN SWITCHING ON OR OFF, PLEASE ENSURE THAT YOUR HANDS ARE DRY
The ‘Cool Tumble’ phase 
About 10 minutes before the programme is completed, the heating elements will be switched off and the programme enters the final ‘Cool Tumble’ phase. During this phase the fabric is cooled. You should always allow the dryer to complete this phase.
By opening the door you can check the dryness of the load as often as you wish and if you want to remove some items before they are fully dry. (This is particularly useful for a mixed load where you want to iron some items, but others are to be fully dried.) You will need to press the start button after closing the door to
8
