The Controls
Start switch | Empty water light |
Heat Selection Switch | Timer |
| Control |
Setting the timer The drying time for both heat settings is controlled by the timer. All you have to do is turn the Timer Control clockwise until the required time appears in line with the indicator.
NEVER WIND THE TIMER CONTROL ANTI-CLOCKWISE.
The “Guide to Drying Times” section will tell you how much time you’ll need for various loads.
Selecting the | To select high heat (Cottons), the Heat Selection switch must be IN. |
required Heat | To select Low heat (Acrylics and Synthetics) the Heat Selection switch |
Setting | must be OUT. |
| See section “Guide to Drying Times”. |
Starting the Dryer | Press and release the START button to commence a drying program |
| (The drying time must have been selected first). |
|
|
| NOTE: If the door is opened during a programme the |
| Dryer will automatically stop. |
| To continue the programme after closing the door, the |
| START button must be pressed. |
|
|
Empty Water | This light will glow when the water container is full. |
Light | You should not wait for this light to glow before emptying the water |
| container, but empty it after each load (see section “Emptying the |
| Water Container”). |
| NOTE: When the light glows you must stop the dryer and empty the |
| water container. |
| If the water light glows during a drying cycle the timer will advance to |
| the Cool Tumble Phase without drying the load. |
| The light will take approximately 10 seconds to go out after replacing |
| the empty container. |
9
