EN
15
Troubleshooting

Possible causes / Solutions:

The plug has not been inserted far enough into the socket to make contact.
There has been a power cut.
The fuse has burned out. Try connecting another appliance to the same socket.
If an extension cord is used, try connecting the dryer plug directly into the socket.
The door has not been closed properly.
The programme has not been set correctly (see How to carry out a drying cycle).
The START/PAUSE button has not been pressed (see How to carry out a drying cycle).
A delayed start time has been set (see Programmes and options).
The START/PAUSE button has been pressed; a short delay follows before the
dryer starts running. Wait for the drying cycle to start; do not press the START/
PAUSE button otherwise the dryer switches to the pause mode and the drying
cycle will not start.
The filter has not been cleaned (see Maintenance).
The water container must be emptied? The Empty water container indicator light
flashes and the message appears H2O (see Maintenance).
The condenser needs to be cleaned (see Maintenance).
The heat setting is not suited to the type of fabric to be dried (see Programmes and
options).
An incorrect drying time was selected for the type of load (see Laundry).
The items are too wet (see Laundry).
The air intake grille are clogged up (see Installation and Care and Maintenance).
The dryer is overloaded (see Laundry).
The water container was probably not emptied before starting the programme. Do
not wait for the signal for emptying the water container, but always check and
empty it before starting a new drying programme (see Description of the tumble
dryer).
It is normal: the Empty water container indicator light flashes when the water
container is full. If the indicator light is on but is not flashing, it only signals that the
water container must be emptied (see Description of the tumble dryer).
!For safety reasons, the dryer programmes last a maximum of 4 hours. If an
automatic programme has not detected the final dampness level required in this
interval, the dryer completes the programme and stops. Check the above points
and repeat the programme; if the items are still damp, contact the Technical
Assistance Centre (see Assistance).
If the display visualises F10 or F15, switch the appliance off and unplug it, then clean
the filter and the condenser (see Maintenance). Reinsert the plug, switch the
appliance on and start another programme. If the display still visualises F10 or F15,
contact the Technical Assistance Centre (see Assistance). If the display still
visualises other numbers, mark the code and contact the Technical Assistance
Centre (see Assistance).
The appliance is in Demo mode. Press the ON/OFF and START/PAUSE buttons
and keep them pressed for 3 seconds. The display visualises dOn for 3
seconds, then the dryer starts functioning normally.
The remaining time is constantly monitored during the drying cycle and is updated
to show the best forecast. It is normal for the displayed time to increase during the
cycle.
This is normal, especially if the dryer has not been used for a long time. If the noise
persists during the entire cycle, contact the Technical Assistance Centre.
If you feel that the dryer is not working properly, consult the following troubleshooting suggestions before contacting the Technical
Assistance Centre (see Assistance).

Problem:

The dryer does not start.
The drying cycle does not start.
Drying times are too long.
The Empty water container
indicator light flashes, but the
dryer has been running for a short
time.
The Empty water container
indicator light is on but the water
container is not full.
The programme is finished but
the items are damper than
expected.
The code F appears on the
display followed by one or two
numbers, the options indicator
lights and the pause indicator
light flash.
dOn briefly appears on the
display every 6 seconds.
The Remaining time indicator
changes during the drying cycle.
The dryer is noisy during the first
few minutes of operation.