Indesit IS60D1 S Adapting to different types of gas, Disposing of the appliance, Adapting the hob

Disposing of the appliance

When disposing of the appliance please remove the plug by cutting the mains cable as close as possible to the plug body and dispose of it as described above.

Checking the connection for leaks

When the installation process is complete, check the hose fittings for leaks using a soapy solution. Never use a flame.

! The hob burners do not require primary air adjustment.	GB
! After adjusting the appliance so it may be used
with a different type of gas, replace the old rating
label with a new one that corresponds to the new
type of gas (these labels are available from
Authorised Technical Assistance Centres).

!Should the gas pressure used be different (or vary slightly) from the recommended pressure, a suitable pressure regulator must be fitted to the inlet hose in accordance with current national regulations relating to “regulators for channelled gas”.

Adapting to different types of gas

It is possible to adapt the appliance to a type of gas other than the default type (this is indicated on the rating label on the cover).

Adapting the hob

Replacing the nozzles for the hob burners:

1.Remove the hob grids and slide the burners off their seats.

2. Unscrew the nozzles using a 7 mm socket spanner (see figure), and replace them with nozzles suited to the new type of gas (see Burner and nozzle

specifications table).

3.Replace all the components by following the above instructions in reverse.

Adjusting the hob burners’ minimum setting:

1.Turn the tap to the minimum position.

2.Remove the knob and adjust the regulatory screw, which is positioned inside or next to the tap pin, until the flame is small but steady.

! If the appliance is connected to a liquid gas supply, the regulatory screw must be fastened as tightly as possible.

3.While the burner is alight, quickly change the position of the knob from minimum to maximum and vice versa several times, checking that the flame is not extinguished.

TABLE OF CHARACTERISTSICS

Dimensions	width 43,5 cm
	height 32 cm
	depth 40 cm
Volume	57 l
Useful	width 46 cm
measurements
	height 8,5 cm
relating to the oven
	depth 42 cm
compartment
	may be adapted for use with any type
Burners	of gas shown on the data plate, which
	is located inside the flap or, after the
	oven compartment has been opened,
	on the left-hand wall inside the oven.
Voltage and	see data plate
frequency
	Directive 2002/40/EC on the label of
	electric ovens.
	Standard EN 50304
	Energy	consumption for Forced
ENERGY LABEL	convection heating mode:
	Fan assisted
	Declared energy consumption for
	Natural convection Class heating
	mode:	Convection
	This appliance conforms to the
	following European Economic
	Community directives: 2006/95/EC
	dated 12/12/06 (Low Voltage) and
	subsequent amendments –
	2004/108/EC dated 15/12/04
	(Electromagnetic Compatibility) and
	subsequent amendments - 93/68/EEC
	dated 22/07/93 and subsequent
	amendments.
	2002/96/EC
	2009/142/EC dated 30/11/09 (Gas)
	1275/2008 (Stand-by/ Off mode)

5