Connecting the drain hose
Do not use extension cords or multiple sockets.
GB
65 - 100 cm |
Connect the drain hose, without bending it, to a drainage duct or a wall drain located at a height between 65 and 100 cm from the floor;
The cable should not be bent or compressed.
The power supply cable must only be replaced by authorised technicians.
Warning! The company shall not be held responsible in the event that these regulations are not respected.
The first wash cycle
alternatively, rest it on the side of a washbasin or bathtub, fastening the duct supplied to the tap (see figure). The free end of the hose should not be underwater.
We advise against the use of hose extensions; if it is absolutely necessary, the extension must have the same diameter as the original hose and must not exceed 150 cm in length.
Electrical connections
Before plugging the appliance into the electricity socket, make sure that:
•the socket is earthed and complies with all applicable laws;
•the socket is able to withstand the maximum power load of the appliance as indicated in the Technical data table (see opposite);
•the power supply voltage falls within the values indicated in the Technical data table (see opposite);
•the socket is compatible with the plug of the washing machine. If this is not the case, replace the socket or the plug.
The washing machine must not be installed outdoors, even in covered areas. It is extremely dangerous to leave the appliance exposed to rain, storms and other weather conditions.
When the washing machine has been installed, the electricity socket must be within easy reach.
Once the appliance has been installed, and before you use it for the first time, run a wash cycle with detergent and no laundry, using the wash cycle 2.
Technical data
Model | IWB 5065 | |||
|
|
|
| |
|
|
| width 59.5 cm | |
Dimensions | height 85 cm | |||
|
|
| depth 52,5 cm | |
|
|
|
| |
Capacity | from 1 to 5 kg | |||
|
|
|
| |
Electrical | please refer to the technical data | |||
connections | plate fixed to the machine | |||
|
|
|
| |
|
|
| maximum pressure 1 MPa (10 bar) | |
Water connections | minimum pressure 0.05 MPa (0.5 bar) | |||
|
|
| drum capacity 46 litres | |
|
|
|
| |
Spin speed | up to 600 rotations per minute | |||
|
|
|
| |
Energy rated |
| |||
programmes | programme 2; temperature 60°C; | |||
according to | ||||
using a load of 5 kg. | ||||
regulation | ||||
| ||||
EN 60456 |
| |||
|
|
|
| |
|
|
| This appliance conforms to the | |
|
|
| following EC Directives: | |
|
|
| - 89/336/EEC dated 03/05/89 | |
|
|
| (Electromagnetic Compatibility) and | |
|
|
| subsequent modifications | |
|
|
| - 2002/96/EC | |
|
|
| - 2006/95/EC Low Voltage) | |
|
|
| ||
3
