InSinkErator Mounting Assemblies
STANDARD MOUNTING ASSEMBLY
1.Place mounting flange (1) over the existing collar adaptor connection lip or sink bowl flange (this may require some force).
2.Push the mounting flange up out of the way and fit the groove in the mounting gasket (2) onto the . connection lip. Make sure the gasket is fully seated . on the flange.
3.Push the mounting flange down over the mounting gasket, fitting the threaded mounting flange fasteners into the recesses in the top of the mounting gasket.
#6 Collar Adaptor
(1)Mounting Flange
(2)Mounting Gasket
(3) Flat Gasket
Disposer Body Flange
1/4” Screw
Figure 6. #6 Mounting Assembly
4.From the bottom, insert two screws through opposite sides of the flat gasket (3) and mounting flange, into the threaded fasteners in the existing flange. The flat gasket is used only in the #6 mounting assembly. The screws should protrude about 1/4" below the mounting gasket.
5.Position the disposer beneath the mounting gasket and raise it to engage the two protruding screws in the disposer body flange keyhole slots. Secure the remaining screws and position the disposer correctly for the plumbing connections. If disposer legs are included, adjust the legs to support the disposer.
#7 Collar Adaptor |
(1) Mounting Flange |
(2) Mounting Gasket |
Disposer Body Flange |
1/4” Screw |
Figure 7. #7 or Sink Bowl Mounting Assembly
SPECIAL INSINKERATOR MOUNTING ASSEMBLIES
When installing an InSinkErator Foodservice disposer to a
6:8. Outward Flange | Figure 7: | Figure 8: Straight Flange |
Figure | Figure 9. Inward Flange | Figure 10. Straight Flange |
8
