Troubleshooting
WASTE XPRESS TROUBLESHOOTING
PROBLEM | POSSIBLE CAUSE | SOLUTION | |
|
|
| |
Waste Xpress unit is extremely wet. | • Excessive moisture in waste being . | • Slow down feed rate of waste to disposer . | |
| processed or high volume of liquids . | while processing.. | |
| being processed through system.. |
| |
|
| • Do not process large volumes of watery . | |
| . | waste by itself - balance waste mix with . | |
|
| other types of food waste and/or disposables | |
| • No flow control valve in cold water . | • Call for service. | |
| line – full line flow from source being . |
| |
| directed to system. |
| |
|
|
| |
Water | • High grease content in waste mix. . | • Call for service. | |
chute while system is running. |
| ||
| cleaned sufficiently and is causing . |
| |
| a "chimney" to form. Hot water . |
| |
| spray cycle "on" time is insufficient . |
| |
| to keep screen clean affecting . |
| |
| water drainage. |
| |
|
|
| |
Processed waste is draining from | • Auger is running in wrong rotation. | • Call for service. | |
cabinet at outlet to sewer – no | • Auger screen pan is facing back . | • Reverse auger screen (see Cleaning . | |
waste exiting Waste Xpress unit at | |||
of machine – processed waste . | Instructions section on page 17). | ||
discharge chute. | |||
falling into base of cabinet and . |
| ||
|
| ||
| exiting at outlet. |
| |
|
|
|
If the Waste Xpress remains inoperative after following this troubleshooting guide, contact InSinkErator’s service department at
23