InSinkErator 14481 manual Waste Xpress 380/460V, 3Phase System Wiring Diagram, Electrical Shock

Waste Xpress 380/460V, 3Phase System Wiring Diagram

ELECTRICAL SHOCK

•Turn off the electrical supply to the disposer before attempting any work on it. Use a voltmeter or . circuit tester to ensure that power is off.

•Installation must conform to local electrical codes.

•All components (disposer, WX, control center . and solenoids) must be carefully and permanently grounded.

•A properly fused disconnect must be installed at the electrical supply source for the control center.

PROPERTY DAMAGE

•Ensure that the control center voltage and phase match the disposer motor and electrical supply. Check nameplates on disposers and control . centers for voltage and phase specification.

•The disposer motor wiring connection is shown in the disposer terminal box.

120 V

380/460 V

1-phase

3-phase

1/2 to 2 HP

Call Toll Free 1-800-845-8345 for the nearest InSinkErator Authorized Service Agency or to reach Technical Support.

26