BLUE | “NEUTRAL” (“ N”) | ||
BROWN | “LIVE” (“L”) | ||
GREEN AND YELLOW | “EARTH” (“E”) | ||
|
|
|
|
| GREEN & |
|
|
| YELLOW |
|
|
| BROWN | 13 amp fuse |
|
|
|
| |
| BLUE |
| |
|
| CORD GRIP |
|
|
|
|
|
Disposing of the appliance
When disposing of the appliance please remove the plug by cutting the mains cable as close as possible to the plug body and dispose of it as described above.
Adapting the cooker to different types of gas
In order to adapt the cooker to a different type of gas with respect to the gas for which it was produced (indicated on the label attached to the lid), follow these steps:
a)Replacing the burner nozzles on the hob:
•remove the grids and slide the burners from their housings;
•unscrew the nozzles using a 7 mm socket spanner, and replace them with nozzles for the new type of gas (see table 1 “Burner and nozzle characteristics”).
•replace all the components by repeating the steps in reverse order.
b)Minimum regulation of the hob burners:
• turn the tap to minimum;
• remove the knob and adjust the regulation screw, which is positioned in or next to the tap pin, until the flame is small but steady.
N.B.: in the case of liquid gas, the regulation screw must be screwed in to the bottom.
• check that the flame does not turn off when you turn the tap quickly from high to low.
c)Regulating the primary air of the burners:
The primary air of the burners requires no regulation.
Adapting to different types of gas
In order to adapt the oven to a different type of gas with respect to the gas for which it was manufactured (indi- cated on the label), follow these simple steps:
a)Replacing the oven burner nozzle · open the oven door fully
· pull out the sliding oven bottom
· unscrew the burner fastening screws
V
·remove screw “V” and then the oven burner;
·Unscrew the oven burner nozzle using the special socket spanner for the nozzles, or a 7 mm socket span- ner, and replace it with a nozzle suited to the new type of gas (see Table 1).
Take particular care handling the spark plug wires and the thermocouple pipes.
·Replace all the parts, following the steps described above in the reverse order.
b)Minimum regulation of the gas oven burner with thermostat:
•light the burner as described in the paragraph “the oven knob” of the instruction booklet.
•turn the knob to Max for about 10 minutes and then turn the knob to the Min setting;
•remove the knob;
•regulate the screw positioned outside the thermostat pin until the flame is small but steady.
N.B.: in the case of liquid gas, the regulation screw must be screwed in to the bottom.
•check that the burner does not turn off when you turn the knob from Max to Min and and when you open and close the oven door quickly.
Adapting the gas grill to different types of gas Replacing the nozzle of the grill burner:
•remove the screw and then slide out the grill burner
“V” (see Fig. E);
6
