HOT PARTS

Important: make sure the supply pressure conforms with the values shown in the table entitled “Caracteristics of the burners and nozzles”. When the cooker is installed between cabinets (recessed), the gas connection must be effected by an approved flexible hose with bayonet fitting (BS 669 Current Edition). The gas inlet for the cookers is a threaded G 1/2 gas female fitting.

Connecting the gas supply

To make the connection, a flexible hose should be used corresponding to the current gas regulations which are:

the hose must never be at any point in its lenght in contact with the “hot” parts of the cooker;

the hose must never be longer than 1,5 metre;

the hose must not be subject to any tension or torsional stress and it must not have any excessively narrow curves or bottlenecks;

the hose must be easy to inspect along its entire length to check its condition;

the hose must always be in good condition, never attempt to repair.

Important: the installation must comply with gas safety (installation and use) regulations 1984. In all cases for the above, by low, a qualified, corgi approved engineer must be called for installation.

Electrial connection

Power supply voltage and frequency:230-240V a.c.50/60 Hz.

Note: the supply cable must be positioned so that it never reaches at any point a temperature 50°C higher than the room temperature.The cable must be routed away from the rear vents. Should you require it, you may use a longer cable, however, you must ensure that the cable supplied with the appliance is replaced by one of the same specifications in accordance with current standards and legislation.

Your appliance is supplied with a 13 amp fused plug that can be plugged into a 13 amp socket for immediate use. Before using the appliance please read the instructions below.

WARNING - THIS APPLIANCE MUST BE EARTHED. THE FOLLOWING OPERATIONS SHOULD BE CARRIED OUT BY A QUALIFIED ELECTRICIAN.

Replacing the fuse:

When replacing a faulty fuse, a 13 amp ASTA approved fuse to BS 1362 should always be used, and the fuse cover re- fitted. If the fuse cover is lost, the plug must not be used until a replacement is obtained.

Removing the plug:

If your appliance has a non-rewireable moulded plug and you should wish to remove it to add a cable extension or to re-route the mains cable through partitions, units etc., please ensure that either:

the plug is replaced by a fused 13 amp re-wireable plug bearing the BSI mark of approval.

or:

the mains cable is wired directly into a 13 amp cable outlet, controlled by a switch, (in compliance with BS 5733) which is accessible without moving the appliance.

Please note: for appliances with a rating greater than 13

amp (eg: electric hob, double ovens and freestanding electric cookers etc.) the mains cable must be wired into a cooker output point with a rating of 45 amp. In this case the cable is not supplied.

Disposing of the plug:

Ensure that before disposing of the plug itself, you make the pins unusable so that it cannot be accidentally inserted into a socket. Instructions for connecting cable to an alternative plug:

Important: the wires in the mains lead are coloured in accordance with the following code:

Green & Yellow

- Earth

Blue

- Neutral

Brown

- Live

If the colours of the wires in the mains lead do not correspond with the coloured markings identifying the terminals in your plug, proceed as follows:

Connect Green & Yellow wire to terminal marked “E” or or coloured Green or Green & Yellow.

Connect Brown wire to terminal marked “L” or coloured Red. Connect Blue wire to terminal marked “N” or coloured Black. If a 13 amp plug (BS 1363) is used it must be fitted with a 13 amp fuse. A 15 amp plug must be protected by a 15 amp fuse, either in the plug or adaptor or at the distribution board. If you are in any doubt about the electrical supply to your machine, consult a qualified electrician before use.

How to connect an alternative plug:

The wires in this mains lead are coloured in accordance with

the following code:

 

 

BLUE

NEUTRAL” (“ N”)

BROWN

LIVE” (“L”)

GREEN AND YELLOW

EARTH” (“E”)

 

 

 

 

 

GREEN &

 

 

 

YELLOW

 

 

 

BROWN

13 amp fuse

 

 

 

 

 

BLUE

CROSS-BAR

 

 

 

CORD GRIP

 

 

 

 

 

Replacement fuse covers:

If a replacement fuse cover is fitted, it must be of the correct colour as indicated by the coloured marking or the colour that is embossed in words on the base of the plug. Replacements can be obtained directly from your nearest Service Depot.

5

Disposing of the appliance

When disposing of the appliance please remove the plug by cutting the mains cable as close as possible to the plug body and dispose of it as described above.

Page 5
Image 5
Indesit K 344 E.C/G Connecting the gas supply, Electrial connection, Replacing the fuse, Removing the plug, Following code

K 344 E.C/G specifications

Indesit K 344 E.C/G is an advanced refrigerator model designed for modern households that prioritize efficiency and functionality. With its elegant design and ample storage capacity, the appliance aims to enhance the kitchen experience while ensuring optimal food preservation.

One of the standout features of the Indesit K 344 E.C/G is its impressive storage versatility. The refrigerator boasts an array of adjustable shelves, allowing users to customize the interior space according to their storage needs. This flexibility is essential for accommodating various sizes of food containers, fresh produce, and beverages. The spacious vegetable drawer is specifically designed to keep fruits and vegetables fresh for longer periods, while a dedicated compartment for dairy products helps maintain the ideal temperature and humidity levels.

In terms of energy efficiency, the Indesit K 344 E.C/G is rated highly, helping users significantly reduce their electricity consumption. This feature not only benefits the environment but also results in lower utility bills. The appliance is engineered to operate quietly, ensuring that it does not disrupt the household's daily activities.

The advanced cooling technologies integrated into the Indesit K 344 E.C/G include No Frost technology, which prevents the build-up of ice and frost inside the freezer compartment. This feature eliminates the need for manual defrosting, which can be tedious and time-consuming. Additionally, the appliance is equipped with intelligent temperature control systems that ensure consistent cooling throughout.

Another highlight of this model is its user-friendly interface, which includes easy-to-use controls and an LED display. This feature allows users to monitor and adjust the temperature settings effortlessly, ensuring that their food remains at the optimal temperature, whether it's fresh produce or frozen items.

The Indesit K 344 E.C/G is also designed with safety in mind, featuring child lock mechanisms to prevent accidental openings. Its stylish exterior, available in various colors, makes it a fitting addition to any kitchen decor.

In conclusion, the Indesit K 344 E.C/G embodies functionality, efficiency, and modern design. With its range of features, innovative technologies, and commitment to food preservation, it stands out as an excellent choice for anyone seeking a reliable and stylish refrigerator for their home.