Installation
Important: before making any adjustements, maintenance etc. to the cooker, first ensure that it is disconnected from the electricity supply.
Positioning
The appliance can therefore be installed next to cabinets, provided the height does not exceed that of the hob.
Levelling
In order to have a perfect levelling of the cooker adjustable feets are supplyed. They can be screwed in the seats positioned in the corners of the cooker base.
Electrical connection
Electric cookers come without a power supply cable. The cooker is designed to operate on an electricity supply which conforms to the electrical data shown on the Rating Plate. The cooker can be connected to the mains only after removing the back panel of the cooker itself with a screwdriver.
N.B.: the following installation procedure must be carried out by a qualified electrician.The electrical installation must comply with the IEE Regulations, Building & local
lUnscrew screw “V” (see fig. A)
lPull and open the junction blok lid
Important: the wires in the mains lead are coloured in accordance with the following code:
Green & Yellow | Earth |
Blue | Neutral |
Brown | Live |
As the colours of the wires in the mains lead may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows:
Green & Yellow wire to terminal marked “E” or |
|
|
|
| or |
|
|
|
| ||
|
|
|
|
coloured Green or Green & Yellow.
Brown wire to terminal marked “L” or coloured Red. Blue wire to terminal marked “N” or coloured Black (see fig. B).
lfix the feeding cable in the special cable stop and close the cover.
N.B.: the power supply cable must have these minimum requirements:
Type:
Section: 3x4 mm2
V |
Fig. A | Fig. B |
Connecting the supply cable to the mains
WARNINGS: THIS APPLIANCE MUST BE EARTHED.
Important: The cooker must be connected to the mains by a switched (double pole) cooker outlet correctly fused with a capacity appropriate to that shown on the cooker Rating Plate. All electrical wiring from the consumer unit to the cooker, via the switched double pole cooker outlet, must be of an acceptable type and current rating as above. Note: the supply cable must be positioned so that it never reaches at any point a temperature 50°C higher than the room temperature. The cable must be routed away from the rear vents.
HOT PARTS
4
