Installation instructions
The model of appliance are indicated on the rating plate on the plinth and is visible when drawer is fully pulled out of runner. The serial number of the cooker is printed on the rating plate.
1)The cooker can be positioned against the side walls of other kitchen furniture. However, if the side walls of the adjacent cabinets don’t withstand up to 60°C temperature rise, a minimum gap of 10 mm (3/8") must be left between the sides and the back of the cooker and the adjacent cabinets for the circulation of air. The wall behind the cooker must be of flameproof material and withstand up to 80°C temperature rise. The cooker is covered by degree of protection X. The height of furniture installed next to the cook must not exceed that of the work top.
Caution: INDESIT are unable to accept any responsibility for failure to comply with the above instructions for cooker installation.
Cable connection to the cooker
To get access to the terminal board remove cover “D” using a screwdriver.
Connection to an electricity supply
These appliances must be instalIed by a competent electrician with all electrical connections in accordance with the Regulations for the Electrical Equipm nt of Buildings, published by the Institution of Electrical Engineers. A
WARNING: This appliance must be earthed
Cable connection to the cooker
The earth screw is located at the back of the cooker near the terminal board. See above diagram.
Important: INDESIT are not liable for any loss or damage caused by the non observance of the above instructions.
IMPORTANT NOTE - It is important when inserting the cable wires (E, L, N) into the relevant slots on the mains terminal block, to ensure the bared wire is cramped between the brass plates of the block, as shown in the diagrams.
D |
|
| |
B | screw | screw | |
The electrical connection must be done in accordance | |||
|
| ||
with following diagram: | plates | bared | |
|
| wire |
plates |
bared wire
Brown L
Bleu N
CORRECTINCORRECT
E
Yellow - Green
Cable H05RRF - 3 x 2,5 mm2
3
