Installation Instructions
UNPACKING THE COOKER
Unpack the components from inside the grill and oven: Check that the following parts are present.
Grill pan and grid | Pan supports |
Main oven shelves (2) | Enamelled burner caps (4) |
Small pan support trivet | Aluminium burner bodies(4) |
Literature |
|
LEVELLING
Four skid feet are fitted which can be adjusted up or down to level the cooker.
CONVERSION FOR USE ON BUTANE (G30) OR PROPANE (G31)
Each burner requires the injector to be replaced and bypass screws adjusted or replaced as follows:
1.Remove the loose hotplate burner parts.
2.Using a 7mm socket, replace the hotplate injectors as appropriate (see table on previous page).
3.
4.Remove the screw on the left hand side of the grill burner and gently slide the burner off the injector.
5.Using a 7mm socket, replace the grill injector as appropriate (see table on previous page).
6.
7.Inside the main oven, remove the central screw securing the burner retainer. Slide the retainer to the right slightly and lift away.
8.Lift the burner assembly and place on the floor of the oven to the right of the burner opening.
9.Using a 7mm socket, replace the oven injector as appropriate (see table on previous page).
10.
11.Carefully pull off the control knobs.
12.Using a narrow flat bladed screwdriver rotate the bypass screws fully clockwise. The main oven and grill bypass screws are located on the body of the taps to the right of the spindle. The hotplate tap bypass screws are located down the centre of the spindle.
13.
14.Secure the
22