Safety - a good habit to get into.
ATTENTION
Read your manual carefully since it contains instructions which will ensure safe installation, use and maintenance of your appliance.
Your Refrigerator is built to International safety standards (EN60) ans has been awarded the European approval mark (IMQ) for compliance with UK electrical safety requirements. It also meets the EC standards on the prevention and elimi- nation of readio interference (EC directive 87/308 - 02.06.89).
1.This appliance is designed to be used indoors and under no circumstances should it be installed outside even if pro- tected by a roof. Leaving the appliance exposed to the rain and whether is exceedingly dangerous.
2.The appliance should be used only by adults and exclu- sively for storing foodstuffs in compliance with the instruc- tions provided in this manual. Under no circumstances should children be allowed to operate, or tamper with, this product.
3.Do not attempt to operate or handle this appliance when barefoot, or with wet hands or feet.
4.It is highly recommended that you do not operate this appli- ance by connecting it to the power supply with extensions or multiple socket plugs. If the refrigerator has been installed be- tween two cabinets, make sure that the supply chord is not dangerously crimped or trapped beneath a heavy object.
5.Never pull the cable or the appliance to remove the plug from the socket; this is exceedingly dangerous.
6.Do not touch the internal cooling elements, especially if your hands are wet, since you could burn or hurt yourself.
7.Before doing any cleaning, disconnect the appliance from the electricity (by pulling out the plug or turning off the gen- eral switch in your home); it is not sufficient to place the temperature regulation knob on 
to cut off the power.
8.Before disposing of your old appliance, remember to break or remove the lock as a safety measure to protect children who might lock themselves inside the appliance when play- ing. In addition, if the appliance is a new one with a lock, keeo the key out of the reach of small children.
9.If your appliance is not operating properly, read the chap- ter entitled, “Trouble Shooting”, which might help you re- solve the problem, before calling an
10.If the power supply cord must be replaced, please contact one of our Customer Service Centers. In some cases, the con- nections are made using special terminals and in others a special tool must be used to access the connections.
11.Do not use electric appliances inside the compartment for food storage, if these are not those recommended by the manufacturer.
12.At the end of the functional life of your appliance – containing cyclopentane gas in the insulation foam and perhaps gas R600a (isobutane) in the refrigeration circuit – the latter should made safe before being sent to the dump. For this operation, please contact your dealer or the Local Organisation in charge of waste disposal.
Installation
Proper installation of the appliance is essential to en- sure the best and most efficient performance of your appliance.
Ventilation
The compressor and condenser generate heat and, there- fore, need to be ventilated properly. Rooms with less than perfect ventilation are not very suited for installation of the appliance. Therefore, it should be installed in a room with an opening (window or French window) that provide the appropriate amount of air
During installation, make sure not to cover or obstruct the grates that allow for proper ventilation of the appliance. For proper ventilation of the appliance, you must leave:
-a space of at least 10 cm between the top part and any cabinets above it;
-a space of at least 5 cm between the sides of the appliance and any adjacent cabinets/walls.
Away from Heat
Avoid positioning the appliance in a place where it is directly exposed to sunlight or near an oven, cook top or the like.
Levelling
The floor should be perfectly level; if not, you can adjust the feet at the front of the appliance.
Earthing
Before making the electrical connection, check that the volt- age shown on the data plate, that you will find on the bot- tom left hand side of the appliance next to the crisper, cor- responds to that of your home and that the socket is earthed in compliance with all current electrical regulations. If the system is not earthed, the manufacturer declines all liability for consequent damages or losses. Do not use adapters or multiple sockets. Position the appliance in such a way that you can access the socket where it is plugged in.
Check the power load
The electrical socket must support the maximum power load of the appliance shown on the data plate (on the bottom left hand side of the appliance next to the crisper).
Before plugging the appliance to the mains
Stand the appliance upright and wait at least 3 hours before plugging the appliance into the mains to ensure proper per- formance.
1 | GB |
