Indesit WAX 120 Temperature control knob, Detergent dispenser, Easy iron, Slow spin 1200/600

Understanding the control panel

Here I’m in command

Making the right choice is important. And it’s easy.	D	F
	E	H	I

CGB A

Programme selector knob Use this knob to select the wash programme.

Turn this knob clockwise only.

To select a programme, you should turn the knob so that the symbol/number of the desired programme is in line with the pointer on the knob.

Now press on/off button G (position I), pilot lamp H will start flashing.

After 5", the setting will be accepted, pilot lamp H will stop flashing (staying lit) and the wash cycle will begin.

Should you wish to interrupt the programme in progress or set a new one, select one of the symbols (Stop/Reset) and wait 5" : when the cancellation has been accepted, pilot lamp H flashes, and you can then turn the appliance off.

After the wash cycle has been set and accepted by the washing machine, turning the knob will have no effect (except for when it is on position Stop/ Reset).

The detergent dispenser with the additional bleach compartment is here.

Temperature control knob

It is used to set the wash tempe- rature in the recommended programme table on pag. 4. It also allows you to reduce the tempe- rature recommended for the selected programme, and even to set a cold wash cycle ().

Detergent dispenser

It is divided into 3 compartments:

1.Detergent for pre-wash;

2.Detergent for the main cycle wash;

3.Fabric conditioner.

The washing machine is equipped with an extra compartment 4 (provided as an accessory) for the bleach, to be inserted in compartment 1.

Easy iron

This function allows your washing to come out of the machine without creases, making it much easier to iron. You can use it with programmes 3-4(Cotton), 5-6-7(Synthetics) and 9-10(Delicates).

Press this button in programmes 5-6-7-9-10and the wash cycle will come to a stop on symbol .You can comple- te it by pressing button E again.

4
	3
1	2

Important: this function should not be used when button F (stain removal) has been pressed.

Slow spin 1200/600

Use this button to reduce the spinning speed from 1200 to 600 rpm for the cotton and linen programmes and from 850 to 600 rpm for the synthetic fabrics programmes.

Stain removal (see page 7) Thanks to this command, the washing machine will carry out a more intensive wash that optimises the effectiveness of the liquid additives, thus allowing more resistant stains to be removed. When you press the stain removal button, you cannot activate the pre-wash.

On-off

When button G is pressed, the washing machine is switched on, when it is not the machine is switched off.

Turning the appliance off does not cancel the selected programme.

The on-off lamp

Lamp H flashes when the appliance is switched on and awaiting a programme to be set. A steady light means the appliance has accepted the selected programme.

The door block lamp

The safety lamp indicates that the washing machine door is locked to prevent it from being opened accidentally. To avoid any damages to lock mechanism, you must wait for the lamp to extinguish, before attempting to open the door which takes around three minutes.

3Instructions for installation and use