Infinity 3.5c manual Speaker Connections, TV Size Selector, High-Pass Filter

Speaker Connections 3

RED = + BLACK = –

STRIPE = + NO STRIPE = –

1.LOOSEN TERMINALS

2.INSERT BARE END; TIGHTEN TERMINALS

120V – 60HZ 6A
AC FUSE	CAUTION!
3A 250V
	For continued protection
	against risk of fire, replace
	only with same type fuse
	and rating
	ATTENTION!
POWER	Utilizer un fusible de
	recharge de meme
	type et calibre

Amplifier/Receiver

Center-Channel

Speaker Outputs

+–

ON OFF ON OFF

INTERMEZZO 3.5c TV

	NONE SMALL LARGE	LED
	HIGH-PASS
	FILTER
+ INPUTS –	CAUTION	ANSIUL-1492
	RISK OF ELECTRIC SHOCK
	AVIS RISQUE CHOC ELECTRIQUE – NE PAS OUVRIR	LR106476
	DO NOT OPEN

AC CORD

TV Size Selector 4 LED Selector 6

This control optimizes the performance of the Intermezzo 3.5c based on the size of the TV on which it is placed.

If you are placing the Intermezzo 3.5c behind a perforated screen for a projection TV, set this switch to “None.”

If you are placing the Intermezzo 3.5c on top of a TV with a diagonal screen size up to about 36," set this switch to “Small.”

If you are placing the Intermezzo 3.5c on top of a TV with a diagonal screen size larger than 36," set this switch to “Large.”

High-Pass Filter 5

When set to “On,” this control limits the low frequencies that the Intermezzo 3.5c will reproduce and allows you to use your processor’s/receiver’s bass-management settings for an ideal blend with a subwoofer.

When set to “Off,” the Intermezzo 3.5c will reproduce the entire frequency range. Use this setting only if your system does not include a subwoofer.

This switch determines whether the green power indicator on the woofer level control 7 will illuminate when the speaker is playing. The setting of this switch does not affect the performance of the speaker in any way.

Setting the Woofer Level Control 7

1.Set the processor’s/receiver’s center-channel-speaker setting to “Small”.

2.Confirm correct setting of Set TV Size selector 4.

3.Using the test tones in your receiver/processor, adjust the center-channel-speaker output (on the processor) to match the left and right speakers.

4.Finally, fine-tune the level adjustment on the Intermezzo 3.5c 7 to most closely match the tonal balance of the main left and right speakers. (For the Intermezzo 4.1t, initially set the center- channel level to “5”For. the Intermezzo 2.6, set to the same setting as the Intermezzo 2.6’s woofer adjustment.)

INTERMEZZO 3.5c 5