
A NOTE ON POWER HANDLING |
| SPECIFICATIONS |
|
|
|
| |
The speakers used in Kappa Series | 40.2cs |
| 60.2cs |
|
| ||
Component Systems are designed to produce rea- | Type: | 4" | Type: | ||||
sonable volume levels with little amplifier power. | Speaker Impedance: | 4 Ohms | Speaker Impedance: | 4 Ohms | |||
However, the addition of an amplifier to drive | Power Handling: | 75W RMS, 300W peak | Power Handling: | 90W RMS, 360W peak | |||
your speakers and a subwoofer will enhance the | Frequency |
| Frequency |
|
| ||
dynamic range of your system, and help over- | Response (±3dB): | 80Hz ~ 21kHz | Response (±3dB): | 50Hz ~ 21kHz | |||
come the ambient noise in a moving vehicle. | Sensitivity: | 89dB | Sensitivity: | 89dB | |||
Kappa speakers are designed to handle the power | Crossover Frequency: | 3.5kHz | Crossover Frequency: | 3.5kHz | |||
of a dedicated amplifier driven at or below its | Mounting Depth, |
| Mounting Depth, | ||||
rated power. If an amplifier is driven far above its | Cutout Diameter: | ||||||
rated power, the output signal will “clip,” and the | Cutout Diameter |
| Cutout Diameter | ||||
additional power present in a clipped signal can | Midrange: |
|
|
| |||
damage any speaker. Distorted or “fuzzy” sound | Cutout Diameter | 652.2cs |
|
| |||
from your speakers is an indication that the ampli- |
|
| Type: | 165mm | |||
fier has exceeded its rated power, and you should | 50.2cs |
| Speaker Impedance: | 4 Ohms | |||
reduce the volume level. | Type: | Power Handling: | 90W RMS, 360W peak | ||||
|
| Speaker Impedance: | 4 Ohms | Frequency |
|
| |
|
| Power Handling: | 85W RMS, 340W peak | Response (±3dB): | 50Hz ~ 21kHz | ||
GENERAL CARE | Frequency |
| Sensitivity: | 89dB | |||
Response (±3dB): | 59Hz ~ 21kHz | Crossover Frequency: | 3.5kHz | ||||
|
| ||||||
|
| Sensitivity: | 89dB | Mounting Depth, | |||
The loudspeaker grilles may be cleaned with a | Crossover Frequency: | 3.5kHz | Cutout Diameter: | ||||
slightly damp cloth. Do not use any cleaners or | Mounting Depth, | Cutout Diameter | |||||
solvents on the grilles or the speaker cones. | Cutout Diameter: |
|
|
| |||
|
| Cutout Diameter |
|
|
|
DECLARATION OF CONFORMITY
We, Harman Consumer International
2, route de Tours
72500
France
declare in own responsibility, that the products described in this owner’s manual are in compliance with technical standards:
Infinity Systems, Inc. • 250 Crossways Park DriveEN
EN
Woodbury, NY 11797 USA • (800)
P/N:INFKAPCSOM