Checking for Blockages
Blockages may cause your vacuum to overheat and shut down. If so, clear the blockages, then follow the instructions for Resetting the Motor Thermostat on page 14.
WARNING: Never insert sharp objects into any opening to clear an obstruction.
IMPORTANT: Damages caused while clearing or attempting to clear blockages are not covered under your product’s limited warranty.
Unplug the vacuum before checking for blockages.
Reassemble all parts securely before operating vacuum.
1
2
34
1Detachable Handle:
Lock vacuum into upright position.
Remove Detachable Handle and Telescopic Wand; disconnect the hose.
Check both openings on the Detachable Handle, hose, and wand for clogs.
2Dust Cup Air Duct:
Lock into upright position.
Remove Dust Cup Assembly and empty Dust Cup, if necessary.
Disconnect the Super Stretch Hose.
Check Air Duct behind Dust Cup for clogs; clear before replacing Dust Cup Assembly.
3Intake Opening behind the Brush Roll:
Lock vacuum and lay flat.
Check opening behind the Brush Roll for clogs.
Clear the opening.
Clear the Brush Roll; use scissors to carefully cut away threads, hair or other debris that might be trapped in the bristles.
4Nozzle Hose Connector:
Remove Dust Cup Assembly.
Lock vacuum, lay flat and turn over.
Use a Phillips Head screwdriver to:
aRemove 2 screws from the access port cover and remove.
bRemove 2 screws to release the Nozzle Hose.
a | b |
Check Nozzle Hose for clogs.
English
1
2
3
www.infinityvac.com
13
